Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › CLEARANCE WARNING ECU
RM27L0U _56 Audio / Visual / Telematics _049331 PARK ASSIST / MONITORING _0235790 CLEARANCE WARNING ECU A

PARK ASSIST / MONITORING  CLEARANCE WARNING ECU  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:

A bolt without a torque specification is show in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).


PROCEDURE

Hide 89340A 1.INSTALL CLEARANCE WARNING ECU ASSEMBLY

a.
E161797

Install the clearance warning ECU to the bracket with the 2 nuts.

NOTICE:
·

Avoid any impact to the clearance warning ECU.

·

Do not drop the ECU. If it is dropped, replace it with a new one.




Hide 82861 2.INSTALL NO. 1 ECU INTEGRATION BRACKET

a.
E191462

Install the No. 1 ECU integration bracket with the bolt and nut.


b.

Connect the ECU connectors and attach the harness clamp.

NOTICE:

Do not apply excessive force to the wire harnesses.



Hide 55045A 3.INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY RH

Hide 55607 6.INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Hide 10.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 11. CHECK SRS WARNING LIGHT