Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM
RM27L0U _56 Audio / Visual / Telematics _049331 PARK ASSIST / MONITORING _0235792 BLIND SPOT MONITOR SYSTEM C

PARK ASSIST / MONITORING  BLIND SPOT MONITOR SYSTEM  C1A45  Vehicle Speed Sensor  


DESCRIPTION

The blind spot monitor sensor receives vehicle speed signals from the skid control ECU via CAN communication.

DTC Code DTC Detection Condition Trouble Area
C1A45 A fail flag is transmitted from the skid control ECU.
·

Vehicle stability control system

·

Blind spot monitor sensor RH

·

Blind spot monitor sensor LH



CAUTION / NOTICE / HINT

NOTICE:

When checking for DTCs, make sure that the blind spot monitor main switch assembly (warning canceling switch assembly) is on.


PROCEDURE

1.CHECK OTHER DTC OUTPUT (VEHICLE STABILITY CONTROL SYSTEM)
a.

Check for DTCs of the vehicle stability control system (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR).

OK:

Vehicle stability control system DTCs are not output.




OK

2.CHECK DTC

NG

REPAIR CIRCUIT INDICATED BY OUTPUT CODE (for Vehicle Stability Control System)

2.CHECK DTC

b.

Recheck for DTCs and check if the same DTC is output again.

Result
Result Proceed to
No DTC is output A
DTC is output from the blind spot monitor sensor RH B
DTC is output from the blind spot monitor sensor LH C



A

B

C