Home › Power Source / Network › 3UR-FE BATTERY / CHARGING › GENERATOR
RM27L0U _57 Power Source / Network _049334 3UR-FE BATTERY / CHARGING _0235801 GENERATOR A

3UR-FE BATTERY / CHARGING  GENERATOR  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 28800 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION)


Hide 16571 6.REMOVE INLET RADIATOR HOSE

Hide 16572 7.DISCONNECT OUTLET RADIATOR HOSE

Hide 44320 10.DISCONNECT VANE PUMP ASSEMBLY

A184959

a.

Disconnect the clamp and 2 power steering connectors.


b.
A163289

Remove the 2 bolts and disconnect the vane pump.


Hide 27020 11.REMOVE GENERATOR ASSEMBLY

a.
A156405

Disconnect the generator connector.


b.

Remove the terminal cap and nut, and disconnect the generator wire.


c.

Remove the bolt and disconnect the wire harness bracket from the generator.


d.
A156406

Remove the 3 bolts, nut and generator.