If the AUTO UP/DOWN function does not operate, the cause may be one or more of the following:
The ECU in the power window regulator motor determines that the power window regulator motor has not been initialized.
The master switch has a malfunction.
The Hall-IC in the driver side power window regulator motor has a malfunction.
The wiring between the master switch and the driver side power window regulator motor is open or short.
Check for DTCs (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>DTC CHECK / CLEAR)
| Result | Proceed to |
|---|---|
| DTC is not output | A |
| B2311 is output | B |
| B2312 is output | C |
| B2313 is output | D |
| LIN communication system DTCs are output | E |
A
B
C
D
E
(See pagePower Source / Network>NETWORKING>LIN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING)
Check that the manual UP/DOWN function using the multiplex network master switch can operate the driver side power window (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>OPERATION CHECK)
Manual UP/DOWN function operates normally.
OK
NG
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Body Electrical / Master Switch / Data List.
According to the display on the Techstream, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| D Door P/W Auto SW | Driver side power window auto UP/ DOWN switch signal / ON or OFF | ON: Driver side power window auto UP/ DOWN switch operated
OFF: Driver side power window switch not operated |
- |
The Techstream display changes normally when master switch is operated.
OK
NG