DTC B1788 Rear Occupant Classification Sensor RH Collision Detection |
| DTC No. | DTC Detection Condition | Trouble Area |
| B1788 |
|
|
| 1.PERFORM ZERO POINT CALIBRATION |
Connect the Techstream to the DLC3.
Turn the ignition switch to the ON position.
Using the Techstream, perform "Zero point calibration" (Click here).
|
| ||||
| OK | |
| 2.PERFORM SENSITIVITY CHECK |
Using the Techstream, perform "Sensitivity check" (Click here).
|
| ||||
| OK | |
| 3.CHECK DTC |
Turn the ignition switch to the ON position.
Clear the DTCs stored in the memory (Click here).
Turn the ignition switch to the LOCK position.
Turn the ignition switch to the ON position.
Check the DTCs (Click here).
|
| ||||
| NG | |
| 4.REPLACE FRONT SEAT ASSEMBLY RH |
Turn the ignition switch to the LOCK position.
Disconnect the negative (-) terminal cable from the battery, and wait for at least 90 seconds.
Replace the front seat assembly RH (Click here for flat type, Click here for manual seat, Click here for power seat).
| NEXT | |
| 5.PERFORM ZERO POINT CALIBRATION |
Connect the negative (-) terminal cable to the battery.
Connect the Techstream to the DLC3.
Turn the ignition switch to the ON position.
Using the Techstream, perform "Zero point calibration" (Click here).
|
| ||||
| OK | |
| 6.PERFORM SENSITIVITY CHECK |
Using the Techstream, perform "Sensitivity check" (Click here).
|
| ||||
| OK | |
| 7.CHECK DTC |
Turn the ignition switch to the ON position.
Clear the DTCs stored in the memory (Click here).
Turn the ignition switch to the LOCK position.
Turn the ignition switch to the ON position.
Check the DTCs (Click here).
|
| ||||
| NG | |
| 8.REPLACE OCCUPANT CLASSIFICATION ECU |
Turn the ignition switch to the LOCK position.
Disconnect the negative (-) terminal cable from the battery, and wait for at least 90 seconds.
Replace the occupant classification ECU (Click here).
| NEXT | |
| 9.PERFORM ZERO POINT CALIBRATION |
Connect the negative (-) terminal cable to the battery.
Connect the Techstream to the DLC3.
Turn the ignition switch to the ON position.
Using the Techstream, perform "Zero point calibration" (Click here).
| NEXT | |
| 10.PERFORM SENSITIVITY CHECK |
Using the Techstream, perform "Zero point calibration" (Click here).
| NEXT | ||
| ||