Home › Vehicle Interior › HEATING / AIR CONDITIONING › FRONT BLOWER MOTOR
RM3650E _58 Vehicle Interior _079885 HEATING / AIR CONDITIONING _0387588 FRONT BLOWER MOTOR A

HEATING / AIR CONDITIONING  FRONT BLOWER MOTOR  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:
·
B475753

Airbag unit.

Danger. Life-threatening injuries.

-

All work on pyrotechnic parts may be carried out by technically experienced and appropriately trained personnel only.

-

Replace any damaged part or ones that have been dropped.

-

Before performing any work on the airbag, always disconnect the battery earth lead from the battery.

-

Airbag unit may only be set down with the cushion (airbag itself) facing upwards.

-

For additional information see: Safety regulations on handling components with gas generators.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION




HINT:
·

Use the same procedure for LHD and RHD vehicles.

·

The procedure listed below is for the LHD vehicles.



PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


CAUTION:
·
B422343

Wait at least 60 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

·

If the airbag deploys for any reason, it may cause a serious accident.



Hide 55607 2.REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Hide 73900 3.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (w/ Passenger Side Knee Airbag)

Hide 87103B 5.REMOVE BLOWER WITH FAN MOTOR SUB-ASSEMBLY

a.
I114831

Disconnect the connector (1) from the blower with fan motor sub-assembly (2).


b.

Remove T20 screws (3).


c.

Pull of the cable clip (4) from the blower with fan motor sub-assembly (2).


d.
I114832

Remove T20 screw (1).


e.

Guide out the hose (2) from the blower with fan motor sub-assembly (3).


f.

Remove the blower with fan motor sub-assembly (3).