Airbag unit.
Danger. Life-threatening injuries.
All work on pyrotechnic parts may be carried out by technically experienced and appropriately trained personnel only.
Replace any damaged part or ones that have been dropped.
Before performing any work on the airbag, always disconnect the battery earth lead from the battery.
Airbag unit may only be set down with the cushion (airbag itself) facing upwards.
For additional information see: Safety regulations on handling components with gas generators.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
for B48:
Click hereGeneral>MAINTENANCE>B48 BATTERY>REMOVAL
for B58:
Click hereGeneral>MAINTENANCE>B58 BATTERY>REMOVAL
Wait at least 60 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.
55607
2.REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for LHD)
55606
3.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for RHD)
73900
4.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (w/ Passenger Side Knee Airbag)
73990
5.REMOVE LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY (for RHD)
87211A
6.REMOVE NO. 2 AIR DUCT (for LHD)
87211
7.REMOVE NO. 1 AIR DUCT (for RHD)
88625A
8.REMOVE NO. 2 COOLER THERMISTOR
Disconnect the connector (1).
Disengage the No. 2 cooler thermistor (2) and remove it from the air conditioning unit assembly (3).