Home › Power Source / Network › POWER DISTRIBUTION › FUSE BOX
RM3650E _57 Power Source / Network _079891 POWER DISTRIBUTION _0387672 FUSE BOX A

POWER DISTRIBUTION  FUSE BOX  INSTALLATION  


PROCEDURE

Hide 1.INSTALL REAR POWER DISTRIBUTION BOX

a.
E415800

Connect all the connectors to the rear power distribution box (1).


b.
E415799

Install the positive battery cable (3).


c.

Tighten the nut (2).

Torque:
15 N*m (153 kgf*cm, 11 ft.*lbf)


d.

If applicable, replace the tie band on the positive battery cable (3).


e.

Close the cover (1).


f.
E415798

Attach the claws (2) to install the rear power distribution box (1) correctly.


g.

Install the screwdriver and transport hook.


Hide 44890D 2.INSTALL AIR COMPRESSOR ASSEMBLY (w/ Repair Kit)

a.

Install the air compressor assembly.


Hide 42606B 3.INSTALL TUBELESS TIRE REPAIR KIT (w/ Repair Kit)

a.

Install the tubeless tire repair kit.


Hide 64730C 4.INSTALL DECK TRIM SIDE BOARD AND DECK SIDE TRIM COVER RH

Hide 66311 5.INSTALL ROPE HOOK (w/ Courtesy Light)

Hide 62608 6.INSTALL SEAT BELT HOLE COVER SUB-ASSEMBLY RH

HINT:

Use the same procedure as for the LH side.

Click hereVehicle Interior>SEAT BELT>FRONT SEAT OUTER BELT ASSEMBLY>INSTALLATION


Hide 64288D 7.CONNECT TRANSVERSE PIPE TRIM

HINT:

Use the same procedure as for the LH side.

Click hereSuspension>REAR SUSPENSION>REAR STRUT BAR>INSTALLATION


Hide 62470A 8.INSTALL ROOF SIDE INNER GARNISH ASSEMBLY RH

HINT:

Use the same procedure as for the LH side.

Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>INSTALLATION


Hide 64716D 9.INSTALL DECK TRIM REAR COVER

Hide 81604 10.INSTALL TRIANGLE REFLECTOR SET

Hide 81330 11.INSTALL NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY

Hide 12.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL