Home › Drivetrain › 8HP51 (AUTOMATIC TRANSMISSION / TRANSAXLE) › B48 TRANSMISSION WIRE
RM3650E _52 Drivetrain _079902 8HP51 AUTOMATIC TRANSMISSION / TRANSAXLE _0387759 B48 TRANSMISSION WIRE A

8HP51 AUTOMATIC TRANSMISSION / TRANSAXLE  B48 TRANSMISSION WIRE  INSTALLATION  


PROCEDURE

Hide 82125 1.INSTALL TRANSMISSION WIRE

a.

Guide in, route and install the transmission wire section for the automatic transmission assembly.


b.
C413362

Install the transmission wire in the back on the cylinder head.


c.

Tighten the E8 bolts (1).

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


d.

Lock the lock (2).


e.

Install the cable (3) in the cable channel.


f.

Secure cable to the clamp (4).


g.
C413365

Connect and lock the connector (1) to the automatic transmission assembly.


h.

Route the cable and fasten it with the clamps (2).


i.
C413364

Connect and lock the connector (1) on the starter assembly.


j.

Route the cable (2) and fasten it with the clamps.


k.
C413363

Connect and lock the connector (1) on the compressor with magnet clutch.


l.

Route the cable and fasten it with the clamp (2).


m.
C413366

Route the transmission wire.


n.

Fasten the transmission wire on the cable clip (3).


o.

Connect the connector (2) to the integrated supply module and lock.


p.

Attach and lock the connector (1).


q.
A442112

Connect all connectors (1) to the ECM from back to front and lock.


r.
A442111

Install the cover (2).

HINT:

The snap-lock couplings (1) must engage audibly.



Hide 58151A 5.INSTALL NO. 1 FLOOR HEAT INSULATOR

HINT:

Use the same as for the No. 2 floor heat insulator.


Hide 58151 6.INSTALL FRONT NO. 1 FLOOR HEAT INSULATOR

Hide 58165C 9.INSTALL FRONT FLOOR COVER RH

HINT:

Use the same procedure as for the LH side.


Hide 51219 10.INSTALL FRONT SUSPENSION MEMBER LOWER PROTECTOR

Hide 11271A 11.INSTALL REAR CYLINDER BLOCK COVER

Hide 12601B 12.INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY

Hide 55788A 13.INSTALL COWL TOP VENTILATOR LOUVER PROTECTOR

Hide 85010 14.INSTALL FRONT WIPER MOTOR AND LINK ASSEMBLY

Hide 15.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL