Home › Steering › STEERING COLUMN › STEERING WHEEL
RM3650E _55 Steering _080257 STEERING COLUMN _0389218 STEERING WHEEL A

STEERING COLUMN  STEERING WHEEL  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:
·

Pyrotechnic components.

Danger! Life-threatening injuries!

-

All work on pyrotechnic parts may be carried out by technically experienced and appropriately trained personnel only.

-

Replace any damaged part or ones that have been dropped.




NOTICE:
·

Electrostatic discharge.

Damage to or destruction of electrical components.

-

Only touch the housings of electrical components. Do not touch pins or multi-pin connectors directly.

-

For additional information see:

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION




HINT:
·

A wheel alignment is not necessary after the removal, installation or replacement.

·

Steering wheel must be replaced if airbag unit has been deployed.

Only with M Sport steering wheel: Impact plate must be replaced if airbag unit has been deployed.

For additional information see:

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>INSPECTION AFTER COLLISION>INSPECTION



PROCEDURE

Hide 45130 1.REMOVE HORN BUTTON ASSEMBLY

Hide 45100 2.REMOVE STEERING WHEEL ASSEMBLY

a.
C413497

Move wheels/steering wheel into straight-ahead driving position.


b.

Unlock and disconnect the plug connections (1) and (2).


c.

Release the 16 mm bolt (3) and pull off the steering wheel assembly.


Hide 84610F 3.REMOVE TRANSMISSION SHIFT SWITCH ASSEMBLY

Hide 84250A 4.REMOVE STEERING PAD SWITCH ASSEMBLY

Hide 45116 5.REMOVE NO. 1 STEERING WHEEL ORNAMENT

a.
C413519

Carefully release and remove the No. 1 steering wheel ornament (1) from the latch mechanisms (2).


Hide 6.REMOVE STEERING WHEEL HEATER CONTROL ASSEMBLY

a.
C413521

Unlock and disconnect the two plug connections (1).


b.

Removing the steering wheel heater control assembly (2).


Hide 45123 7.REMOVE STEERING WHEEL MOTOR

a.
C413522

Loosen T20 screw (1).


b.

Put the cable (2) to one side.


c.
C417464

Unlock plug connection (1) and disconnect.


d.

Loosen T20 screw (2).


e.

Remove steering wheel motor (3).


Hide 8.REMOVE STEERING WHEEL WIRING HARNESS

a.
C413524

Feed out the steering wheel wiring harness (1).