Home › Engine / Hybrid System › B48 (ENGINE MECHANICAL) › OIL FILTER BRACKET
RM3650E _51 Engine / Hybrid System _080178 B48 ENGINE MECHANICAL _0388868 OIL FILTER BRACKET A

B48 ENGINE MECHANICAL  OIL FILTER BRACKET  INSTALLATION  


PROCEDURE

Hide 15671 1.INSTALL OIL FILTER BRACKET

NOTICE:

The sealing surfaces must be free from oils, grease and cleaning agents.


a.
A441778

Replace the oil filter bracket gaskets (1), (2) and (3) on the oil filter bracket.


b.
A441779

Have a cloth ready.


c.

Crank the engine with the special tool 0 493 380 (11 6 480) until engine oil flows from the oil ducts into the area of the oil filter bracket.

SST
09200-WA190  

NOTICE:
·

Damage to the surface.

The use of metal-cutting tools (e.g. sandpaper) to clean the surfaces can damage them and lead to leaks or engine damage.

-

Do not use any metal-cutting tools.





d.

Remove sealing residue from the crankcase (1) and the oil filter bracket with the special tool 0 495 102 (11 4 470).

SST
09900-WA030  


e.

Guide in the oil filter bracket from the top and position it.


f.
A441769

Tighten E10 bolts in the order (1) to (5).

Torque:
8.0 N*m (82 kgf*cm, 6 ft.*lbf)


g.
A441777

Fasten the cable clip (1) on the oil filter bracket (2).


h.
A441776

Attach the cable (2) and tighten the nut (1).

Torque:
19 N*m (194 kgf*cm, 14 ft.*lbf)


Hide 17138B 2.INSTALL INTAKE MANIFOLD STAY

a.
A441839

Install the intake manifold stay (2).


b.

Tighten down E10 bolt (1).

i.

Note: Tighten the bolt from the bottom.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)



Hide 16282F 3.INSTALL NO. 5 WATER BY-PASS HOSE

a.
A441838

Install the No. 5 water by-pass hose (1).

HINT:

Make sure that the connections are locked correctly. The locks must engage audibly.



b.

Connect and lock the No. 5 water by-pass hose (1).


c.
A441837

Connect and lock the heater water hose (1).

HINT:

Make sure that the connections are locked correctly. The locks must engage audibly.



Hide 16267K 4.INSTALL NO. 3 WATER BY-PASS HOSE

a.
A441812

Attach the No. 3 water by-pass hose.


b.

Lock the retaining clip (1).


Hide 15620 6.INSTALL OIL FILTER CAP ASSEMBLY

Hide 12180E 8.INSTALL OIL FILLER CAP ASSEMBLY

Hide 51219 9.INSTALL FRONT SUSPENSION MEMBER LOWER PROTECTOR

Hide 10.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Hide 11.ADD ENGINE COOLANT (for Low Temperature)

Hide 12.ADD ENGINE COOLANT (for High Temperature)

Hide 14. CHECK ENGINE OIL LEVEL