Home › TRANSMISSION · A340E AUTOMATIC TRANSMISSION › AUTOMATIC TRANSMISSION SYSTEM

AUTOMATIC TRANSMISSION SYSTEM > PROBLEM SYMPTOMS TABLE

for Preparation Click here


HINT:
  1. If a normal code is displayed during the DTC check although the trouble still occurs, check the electrical circuits for each symptom in the order given in the charts below and proceed to the "See page" given for troubleshooting.
  2. The Matrix Chart is divided into 2 chapters.
  3. *1: When the circuit is defective, a DTC may be output.


Refer to the table below when the cause of the trouble is considered to be electrical. If the instruction "Proceed to next circuit inspection shown on matrix chart" is given in the flowchart of the circuit, proceed to the next circuit in the table to continue the check. If the trouble still occurs even though there are no abnormalities in any of the other circuits, check the ECM and replace it if necessary.
Chapter 1: Electronic Circuit Matrix Chart 
Symptom
Suspected Area
See page
No up-shift (1st to 2nd)
Shift solenoid valve (S2) circuit *1
Click here
Speed sensor SP2 circuit *1
Click here
ECM
Click here
No up-shift (2nd to 3rd)
Shift solenoid valve (S1) circuit *1
Click here
ECM
Click here
No up-shift (3rd to 4th)
Park/neutral position switch circuit *1
Click here
Engine coolant temperature sensor circuit *1
Click here
Shift solenoid valve (S2) circuit *1
Click here
ECM
Click here
No down-shift (4th to 3rd)
Park/neutral position switch circuit *1
Click here
Shift solenoid valve (S2) circuit *1
Click here
ECM
Click here
No down-shift (3rd to 2nd)
Shift solenoid valve (S1) circuit *1
Click here
ECM
Click here
No down-shift (2nd to 1st)
Shift solenoid valve (S2) circuit *1
Click here
ECM
Click here
No lock-up or no lock-up off
Shift solenoid valve (SLU) circuit *1
Click here
Stop light switch circuit *1
Click here
ECM
Click here
No lock-up
Shift solenoid valve (SLU) circuit *1
Click here
Engine coolant temperature sensor circuit *1
Click here
Stop light switch circuit *1
Click here
Speed sensor NCO circuit *1
Click here
ECM
Click here
No lock-up off
Shift solenoid valve (SLU) circuit *1
Click here
ECM
Click here
Shift point too high or too low
Shift solenoid valve (SLT) circuit *1
Click here
Speed sensor NCO circuit *1
Click here
Speed sensor SP2 circuit *1
Click here
Throttle position sensor circuit *1
Click here
ATF temperature sensor THOC circuit *1
Click here
ATF temperature sensor THO1 circuit *1
Click here
ECM
Click here
Up-shift to 2nd while in L position
Park/neutral position switch circuit *1
Click here
ECM
Click here
Up-shift to 3rd while in 2 position
Park/neutral position switch circuit *1
Click here
ECM
Click here
Up-shift from 3rd to 4th while engine is cold
Engine coolant temperature sensor circuit *1
Click here
ECM
Click here
Harsh engagement (N to D)
Shift solenoid valve (SLT) circuit *1
Click here
Speed sensor NCO circuit *1
Click here
ECM
Click here
Harsh engagement (Lock-up)
Speed sensor NCO circuit *1
Click here
Speed sensor SP2 circuit *1
Click here
Shift solenoid valve (SLU) circuit *1
Click here
ECM
Click here
Harsh engagement (Any driving position)
Throttle position sensor circuit *1
Click here
Shift solenoid valve (SLU) circuit *1
Click here
Shift solenoid valve (SLT) circuit *1
Click here
Speed sensor NCO circuit *1
Click here
ECM
Click here
Poor acceleration
Shift solenoid valve (SLT) circuit *1
Click here
ECM
Click here
No engine braking
ECM
Click here
No kick-down
ECM
Click here
Engine stalls when starting off or stopping
Shift solenoid valve (SLU) circuit *1
Click here
ECM
Click here

(▲: A340E AUTOMATIC TRANSMISSION Repair Manual Pub. No. RM998U)
Chapter 2: On-Vehicle Repair and Off-Vehicle Repair 
Symptom
Suspected Area
See page
Vehicle does not move with shift lever in any forward position or reverse position
Shift solenoid valve SLT
Click here
Transmission control cable
Click here
Manual valve
▲
Parking lock pawl
▲
O/D one-way clutch (F0)
▲
O/D direct clutch (C0)
▲
O/D brake (B0)
▲
O/D planetary gear unit
▲
Torque converter assembly
Click here
Vehicle does not move in R position
2nd coast brake (B1)
▲
Front and rear planetary gear unit
▲
Direct clutch (C2)
▲
1st and reverse brake (B3)
▲
O/D direct clutch (C0)
▲
No up-shift (1st to 2nd)
1-2 shift valve
▲
2nd brake (B2)
▲
No. 1 one-way clutch (F1)
▲
No up-shift (2nd to 3rd)
2-3 shift valve
▲
Direct clutch (C2)
▲
No up-shift (3rd to 4th)
3-4 shift valve
▲
O/D brake (B0)
▲
No down-shift (4th to 3rd)
3-4 shift valve
▲
No down-shift (3rd to 2nd)
2-3 shift valve
▲
No down-shift (2nd to 1st)
1-2 shift valve
▲
2nd coast brake (B1)
▲
2nd brake (B2)
▲
No lock-up or no lock-up off
Lock-up control valve
▲
Lock-up relay valve
▲
Torque converter assembly
Click here
Harsh engagement (N to D)
Accumulator control valve
▲
Forward clutch (C1)
▲
Harsh engagement (Lock-up)
Lock-up control valve
▲
Lock-up relay valve
▲
Torque converter assembly
Click here
Harsh engagement (N to R)
Accumulator control valve
▲
C2 accumulator
▲
Direct clutch (C2)
▲
1st and reverse brake (B3)
▲
Harsh engagement (N to L)
Low coast modulator valve
▲
Harsh engagement (1st to 2nd, 2nd to 3rd and 3rd to 4th)
Accumulator control valve
▲
Throttle valve
▲
Harsh engagement (2nd to 3rd)
Accumulator control valve
▲
C2 accumulator
▲
2nd coast brake (B1)
▲
Harsh engagement (3rd to 4th)
Accumulator control valve
▲
Solenoid modulator valve
▲
O/D direct clutch (C0)
▲
O/D brake (B0)
▲
O/D planetary gear unit
▲
Harsh engagement (4th to 3rd)
Accumulator control valve
▲
C0 accumulator
▲
O/D brake (B0)
▲
Slippage or shuddering (Forward and reverse: After warm-up)
Shift solenoid valve SLT
Click here
Transmission control cable
Click here
Oil strainer
▲
Pressure relief valve
▲
Torque converter assembly
▲
O/D one-way clutch (F0)
▲
O/D direct clutch (C0)
▲
Slippage or shuddering (Particular position: Just after engine starts)
Shift solenoid valve SLT
Click here
Transmission control cable
Click here
Torque converter assembly
Click here
Slippage or shuddering (R position)
Direct clutch (C2)
▲
1st and reverse brake (B3)
▲
Slippage or shuddering (1st)
Forward clutch (C1)
▲
No. 2 one-way clutch (F2)
▲
Slippage or shuddering (2nd)
2nd brake (B2)
▲
2nd coast brake (B1)
▲
No. 1 one-way clutch (F1)
▲
Slippage or shuddering (3rd)
Direct clutch (C2)
▲
Slippage or shuddering (4th)
O/D brake (B0)
▲
Engine brake does not work only in 1st gear at L position
Low coast modulator valve
▲
1st and reverse brake (B3)
▲
Engine brake does not work only in 2nd gear at 2 position
2nd coast modulator valve
▲
2nd coast brake (B1)
▲
Engine brake does not work only in 3rd gear at 3 position
O/D direct clutch (C0)
▲
Engine brake does not work only in 1st to 4th gear at D position
O/D direct clutch (C0)
▲
No kick-down
1-2 shift valve
▲
2-3 shift valve
▲
3-4 shift valve
▲
Poor acceleration (All positions)
Torque converter assembly
Click here
Poor acceleration (4th)
O/D direct clutch (C0)
▲
O/D planetary gear unit
▲
Poor acceleration (other than 4th)
O/D brake (B0)
▲
Poor acceleration (other than 2nd)
2nd coast brake (B1)
▲
2nd brake (B2)
▲
Poor acceleration (1st and 2nd)
Direct clutch (C2)
▲
Poor acceleration (L and R positions)
1st and reverse brake (B3)
▲
Poor acceleration (R position)
Forward clutch (C1)
▲
Engine stalls when starting off or stopping
Torque converter assembly
Click here