Home › BODY ELECTRICAL › AUDIO / VISUAL › AUDIO AND VISUAL SYSTEM (for CrewMax)

AUDIO AND VISUAL SYSTEM (for CrewMax) > Television Display Assembly Communication Error

for Preparation Click here


INSPECTION PROCEDURE

1.IDENTIFY COMPONENT SHOWN BY SUB-CODE


  1. Enter the diagnostic mode.


    E110917E13

  1. Press the preset switch "2" to change to "Detailed Information Mode".

  1. Identify the component shown by the sub-code.

    HINT:
    1. "190 (radio receiver)" is the component shown by the sub-code in the example shown in the illustration.
    2. For details of the DTC display, refer to the "DTC CHECK/CLEAR" (Click here).


NEXT


2.CHECK POWER SOURCE CIRCUIT OF COMPONENT SHOWN BY SUB-CODE
  1. Inspect the power source circuit of the component shown by the sub-code.
    If the power source circuit is operating normally, proceed to the next step.

    HINT:
    The "Bluetooth" handsfree module is built into the radio receiver.


    Component table 
    Component
    Proceed to
    Radio receiver (190)
    Radio receiver power source circuit (Click here)
    "Bluetooth" handsfree module (19D)
    Radio receiver power source circuit (Click here)
    Stereo component amplifier (440)
    Stereo component amplifier power source circuit (Click here)


NEXT


3.INSPECT RADIO RECEIVER


    E145834E03
  1. Disconnect the K4 and K22* receiver connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    K4-5 (ATX+) - K4-15 (ATX-)
    Always
    60 to 80 Ω
    K22-9 (TXM+) - K22-10 (TXM-)*
    Always
    60 to 80 Ω

    HINT:
    *: w/ Rear Seat Entertainment System

    Result: 
    Result
    Proceed to
    OK
    A
    NG (for Column Shift Type)
    B
    NG (for Floor Shift Type)
    C



B
REPLACE RADIO RECEIVER (Click here)

C
REPLACE RADIO RECEIVER (Click here)
A


4.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - COMPONENT SHOWN BY SUB-CODE)

E142358E03

HINT:
  1. Start the check from the circuit that is near the component shown by the sub-code first.
  2. For details of the connectors, refer to the "Terminals of ECU" (Click here).

  1. Referring to the AVC-LAN wiring diagram below, check the AVC-LAN circuit between the radio receiver and the component shown by the sub-code.

    1. Check for an open or short in the AVC-LAN circuit between the radio receiver and the component shown by the sub-code.

      OK:
      There is no open or short circuit.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


5.REPLACE COMPONENT SHOWN BY SUB-CODE
  1. Replace the component shown by the sub-code with a normal one and check if the same problem occurs again.

    OK:
    Same problem does not occur.



NG
REPLACE TELEVISION DISPLAY ASSEMBLY (Click here)
OK

END