22030
1.INSTALL THROTTLE BODY ASSEMBLY
Align the protrusion of a new gasket with the groove of the intake manifold, and install the gasket.
| *1 | Gasket |
| *a | Groove |
| *b | Protrusion |
Install the throttle body assembly with the 4 bolts.
89421B
2.INSTALL MANIFOLD ABSOLUTE PRESSURE SENSOR
44774
3.INSTALL UNION TO CONNECTOR TUBE HOSE ASSEMBLY
Install the 2 wire harness brackets with the 2 bolts.
Install the union to connector tube hose assembly with the 2 bolts.
Connect the union to connector tube hose to the intake manifold, and slide the clamp to secure the hose.
23829A
4.INSTALL PURGE VSV
Install the purge VSV with the bolt.
Connect the purge line hose to the intake manifold, and slide the clamp to secure the hose.
25860
5.INSTALL VACUUM SWITCHING VALVE ASSEMBLY (for ACIS)
Install the vacuum switching valve assembly with the bolt.
Connect the 2 vacuum hoses to the vacuum switching valve assembly.
6.INSTALL STUD BOLT
Using an E5 "TORX" socket wrench, install the 2 stud bolts.
11254B
7.INSTALL V-BANK COVER BOLT
Install the V-bank cover bolt to the intake manifold.
11254
8.INSTALL V-BANK COVER BRACKET
Install the V-bank cover bracket with the 2 bolts.
23901
9.INSTALL FUEL TUBE SUB-ASSEMBLY
Install the fuel tube sub-assembly to the intake manifold with the bolt.
17111
10.INSTALL INTAKE MANIFOLD
Place 2 new gaskets on the intake manifold.
Place the intake manifold on the cylinder head sub-assembly.
Install and uniformly tighten the 8 bolts and 2 nuts in several steps.
Connect the fuel tube sub-assembly to the fuel delivery pipe sub-assembly LH (See page Engine / Hybrid System>1UR-FE FUEL>FUEL SYSTEM>PRECAUTION).
Connect the fuel tube sub-assembly to the fuel delivery pipe sub-assembly RH (See page Engine / Hybrid System>1UR-FE FUEL>FUEL SYSTEM>PRECAUTION).
Attach the 4 clamps to the fuel tube sub-assembly.
Attach the 3 engine wire harness clamps to the 3 wire harness brackets.
Install the bolt.
Connect the vacuum hose to the union to connector tube hose assembly, and slide the clamp to secure the hose.
Connect the purge line hose to the purge VSV, and slide the clamp to secure the hose.
Connect the 2 vacuum switching valve connectors.
Connect the ventilation hose to the intake manifold, and slide the clamp to secure the hose.
Connect the No. 4 water by-pass hose to the front water by-pass joint, and slide the clamp to secure the hose.
Connect the throttle body connector to the throttle body assembly.
12263
11.INSTALL VENTILATION HOSE ASSEMBLY
Install the ventilation hose assembly with the bolt.
Connect the ventilation hose assembly to the ventilation pipe of the cylinder head cover sub-assembly LH and cylinder head cover sub-assembly RH, and slide the 2 clamps to secure the hose.
12.INSTALL AIR TUBE SUB-ASSEMBLY LH
55701J
13.INSTALL COWL TOP OUTER PANEL SUB-ASSEMBLY
Install the cowl top outer panel sub-assembly with the 7 bolts.
Connect the washer hose and attach the 2 wire harness clamps.
14.INSTALL FRONT WIPER MOTOR AND LINK ASSEMBLY
25620
15.INSTALL EGR VALVE ASSEMBLY
16.INSPECT FOR FUEL LEAK