Home › Drivetrain › WF1AM TRANSFER › TOUCH SELECT 2-4 AND HIGH-LOW SYSTEM
RM27M0U _52 Drivetrain _049122 WF1AM TRANSFER _0234104 TOUCH SELECT 2-4 AND HIGH-LOW SYSTEM C

WF1AM TRANSFER  TOUCH SELECT 2-4 AND HIGH-LOW SYSTEM  P17AA  Transfer Shift Motor Control Circuit High  


DESCRIPTION

This DTC is detected when a short to B+ is detected in the transfer shift motor drive circuit.

DTC Code DTC Detection Condition
1.

Diagnosis Condition

2.

Malfunction Status

3.

Malfunction Time

4.

Other


Trouble Area
P17AA
1.

Ignition switch ON (when transfer shift motor is not operating)

2.

Short to B+ in the transfer shift motor drive circuit

3.

1 second or more

4.

1 trip detection logic


·

Wire harness and connector

·

4 wheel drive control ECU

·

Transfer shift actuator assembly



WIRING DIAGRAM

PROCEDURE

1.CHECK TRANSFER SHIFT ACTUATOR ASSEMBLY (TRANSFER SHIFT MOTOR)
U152690E02
1.125,1.667 0.573,2.542 false 1.458,1.667 1.906,2.594 false 1.583,0.792 1.917,0.969 0.333,0.177 10 false A26 0.375,2.573 0.719,2.802 0.344,0.229 10 false TM1 1.802,2.615 2.146,2.844 0.344,0.229 10 false TM2 0.167,0.177 0.5,0.406 0.333,0.229 10 false *a

a.

Disconnect the 4 wheel drive control ECU connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
A26-1 (TM1) or A26-2 (TM2) - Body ground Ignition switch ON Below 1 V


Text in Illustration
*a Front view of wire harness connector
(to 4 Wheel Drive Control ECU)



OK

REPLACE 4 WHEEL DRIVE CONTROL ECU

NG

2.CHECK HARNESS AND CONNECTOR (4 WHEEL DRIVE CONTROL ECU AND TRANSFER SHIFT ACTUATOR ASSEMBLY - BODY GROUND)
2.CHECK HARNESS AND CONNECTOR (4 WHEEL DRIVE CONTROL ECU AND TRANSFER SHIFT ACTUATOR ASSEMBLY - BODY GROUND)
a.

Disconnect the A26 4 wheel drive control ECU connector.


b.

Disconnect the D67 transfer shift actuator assembly connector.


c.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
A26-1 (TM1) or D67-1 (TM1) - Body ground Ignition switch ON Below 1 V
A26-2 (TM2) or D67-2 (TM2) - Body ground Ignition switch ON Below 1 V




OK

REPLACE TRANSFER SHIFT ACTUATOR ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR