Home › Drivetrain › WF1AM TRANSFER › TRANSFER INDICATOR SWITCH
RM27M0U _52 Drivetrain _049122 WF1AM TRANSFER _0234112 TRANSFER INDICATOR SWITCH A

WF1AM TRANSFER  TRANSFER INDICATOR SWITCH  INSTALLATION  


PROCEDURE

Hide 84222F 1.INSTALL TRANSFER INDICATOR SWITCH

a.

Using SST, install the transfer indicator switch.

SST
09224-00010  

Torque:
41 N*m (413 kgf*cm, 30 ft.*lbf)

NOTICE:

Use the formula below to calculate special torque values for situations where SST is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).



b.

Connect the connector and attach the clamp.


Hide 17450B 2.INSTALL FRONT NO. 2 EXHAUST PIPE ASSEMBLY

Hide 37140 3.INSTALL FRONT PROPELLER SHAFT ASSEMBLY