33820
1.INSTALL COLUMN SHIFT TRANSMISSION CONTROL CABLE ASSEMBLY
Insert the column shift transmission control cable from the vehicle interior, and install the cable retainer with the 2 bolts.
Connect the cable to the steering column shaft bracket so that the outer cable socket's claws attach securely.
Connect the column shift transmission control cable end to the column shift.
Make sure to install the cable end so that the inner cable is not twisted. Confirm that the cable end's ridged side is facing upward.
Connect the 2 cable clamps with the 2 bolts.
Return the floor carpet front LH side to its original position.
Move the shift lever to the N position.
Turn the control shaft lever counterclockwise until it stops, and then turn it clockwise 2 notches to set it to the N position.
Connect the control cable with a new clip and the nut.
When connecting the cable to the transmission control shaft lever, make sure the cable's L bracket faces the inside of the vehicle.
Connect the transmission control cable support with the nut.
2.INSTALL FRONT SEAT ASSEMBLY LH
for Power Seat Type:
Install the front seat LH (see page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Power Seat)>INSTALLATION).
for Manual Seat Type:
Install the front seat LH (see page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Manual Seat)>INSTALLATION).
3.ADJUST SHIFT LEVER POSITION
4.INSPECT SHIFT LEVER POSITION
45286B
5.INSTALL UPPER STEERING COLUMN COVER
45287
6.INSTALL LOWER STEERING COLUMN COVER
55479B
7.INSTALL CENTER LOWER INSTRUMENT COVER
73900
8.INSTALL LOWER NO. 1 INSTRUMENT PANEL AIR BAG ASSEMBLY
55046A
9.INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH
62112
10.INSTALL COWL SIDE TRIM BOARD LH
67914
11.INSTALL FRONT DOOR SCUFF PLATE LH (for Double Cab, CrewMax)
67914
12.INSTALL FRONT DOOR SCUFF PLATE LH (for Regular Cab)
45100
13.INSTALL STEERING WHEEL ASSEMBLY