73960A
1.INSTALL FRONT PASSENGER AIRBAG ASSEMBLY
Attach the 5 hooks (A).
Attach the 5 hooks (B) and install the front passenger airbag on the instrument panel.
Install the 2 screws.
82143C
2.INSTALL NO. 3 INSTRUMENT PANEL WIRE
Attach the wire harness clamp to install the No. 3 instrument panel wire.
Connect the connector.
When handling the airbag connector, take care not to damage the airbag wire harness.
82142A
3.INSTALL NO. 2 INSTRUMENT PANEL WIRE
Attach the wire harness clamp to install the No. 2 instrument panel wire.
Connect the 2 connectors.
When handling the airbag connector, take care not to damage the airbag wire harness.
55972C
4.INSTALL NO. 2 SIDE DEFROSTER NOZZLE DUCT
55844
5.INSTALL NO. 2 HEATER TO REGISTER DUCT
55950G
6.INSTALL DEFROSTER NOZZLE ASSEMBLY
55301
7.INSTALL INSTRUMENT PANEL SUB-ASSEMBLY
Refer to the procedures from "INSTALL INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY" (for Column Shift Type) (see page Vehicle Interior>INTERIOR PANEL>INSTRUMENT PANEL SAFETY PAD(for Column Shift Type)>INSTALLATION).
Refer to the procedures from "INSTALL INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY" (for Floor Shift Type) (see page Vehicle Interior>INTERIOR PANEL>INSTRUMENT PANEL SAFETY PAD(for Floor Shift Type)>INSTALLATION).
8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
9.CHECK SRS WARNING LIGHT
Check the SRS warning light (see page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>DIAGNOSIS SYSTEM).