1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
55301
3.REMOVE INSTRUMENT PANEL SUB-ASSEMBLY
Refer to the procedures up to "REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY" (for Column Shift Type) (see page Vehicle Interior>INTERIOR PANEL>INSTRUMENT PANEL SAFETY PAD(for Column Shift Type)>REMOVAL).
Refer to the procedures up to "REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY" (for Floor Shift Type) (see page Vehicle Interior>INTERIOR PANEL>INSTRUMENT PANEL SAFETY PAD(for Floor Shift Type)>REMOVAL).
55950G
4.REMOVE DEFROSTER NOZZLE ASSEMBLY
55844
5.REMOVE NO. 2 HEATER TO REGISTER DUCT
55972C
6.REMOVE NO. 2 SIDE DEFROSTER NOZZLE DUCT
82142A
7.REMOVE NO. 2 INSTRUMENT PANEL WIRE
Disconnect the 2 connectors.
When handling the airbag connector, take care not to damage the airbag wire harness.
Detach the wire harness clamp and remove the No. 2 instrument panel wire.
82143C
8.REMOVE NO. 3 INSTRUMENT PANEL WIRE
Disconnect the connector.
When handling the airbag connector, take care not to damage the airbag wire harness.
Detach the wire harness clamp and remove the No. 3 instrument panel wire.
73960A
9.REMOVE FRONT PASSENGER AIRBAG ASSEMBLY
Remove the 2 screws.
Detach the 5 hooks (A).
Detach the 5 hooks (B) and remove the front passenger airbag from the instrument panel.