Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › SIDE AIRBAG SENSOR(for Regular Cab)
RM27M0U _58 Vehicle Interior _049131 SUPPLEMENTAL RESTRAINT SYSTEMS _0234213 SIDE AIRBAG SENSOR(for Regular Cab) A

SUPPLEMENTAL RESTRAINT SYSTEMS  SIDE AIRBAG SENSOR(for Regular Cab)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 69284C 3.REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG LH (for Front Side)

Hide 74232 4.REMOVE FRONT UPPER ARMREST BASE PANEL LH (for Front Side)

Hide 69260 5.REMOVE FRONT DOOR WINDOW REGULATOR HANDLE ASSEMBLY (for Front Side)

Hide 67492A 6.REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH (for Front Side)

Hide 67602 7.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH (for Front Side)

Hide 8.REMOVE FRONT SIDE AIRBAG SENSOR

a.
B165651

Disconnect the connector.


b.

Remove the screw and side airbag sensor.


Hide 67914 9.REMOVE FRONT DOOR SCUFF PLATE LH (for Rear Side)

Hide 10.REMOVE REAR SIDE AIRBAG SENSOR

a.
B166507

Remove the bolt and side airbag sensor from the body.


b.

Disconnect the connector.