Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › SIDE AIRBAG SENSOR(for CrewMax)
RM27M0U _58 Vehicle Interior _049131 SUPPLEMENTAL RESTRAINT SYSTEMS _0234219 SIDE AIRBAG SENSOR(for CrewMax) A

SUPPLEMENTAL RESTRAINT SYSTEMS  SIDE AIRBAG SENSOR(for CrewMax)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 69284C 3.REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG LH (for Front Side)

Hide 74232 4.REMOVE FRONT UPPER ARMREST BASE PANEL LH (for Front Side)

Hide 67492A 5.REMOVE FRONT LOWER DOOR FRAME BRACKET GARNISH LH (for Front Side)

Hide 67602 6.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH (for Front Side)

Hide 7.REMOVE FRONT SIDE AIRBAG SENSOR

a.
B166953

Disconnect the connector.


b.

Remove the screw and side airbag sensor.


Hide 8.REMOVE REAR SEAT ASSEMBLY (for Rear Side)

Hide 67918B 9.REMOVE REAR DOOR SCUFF PLATE LH (for Rear Side)

Hide 62332A 10.REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH (for Rear Side)

Hide 62540 11.REMOVE LOWER QUARTER TRIM PANEL ASSEMBLY LH (for Rear Side)

Hide 12.REMOVE REAR SIDE AIRBAG SENSOR

a.
B166508

Remove the bolt and side airbag sensor.


b.

Disconnect the connector.