Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY
RM27M0U _58 Vehicle Interior _049131 SUPPLEMENTAL RESTRAINT SYSTEMS _0234221 FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY A

SUPPLEMENTAL RESTRAINT SYSTEMS  FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 67913 3.REMOVE FRONT DOOR SCUFF PLATE RH (for Regular Cab)

Hide 67913 4.REMOVE FRONT DOOR SCUFF PLATE RH (for Double Cab, CrewMax)

Hide 55607 6.REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Hide 73990 8.REMOVE LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY

a.
B226007

Remove the 3 bolts and remove the instrument panel airbag.


b.

Disconnect the connector.

NOTICE:

When handling the airbag connector, take care not to damage the airbag wire harness.