Home › Vehicle Interior › SEAT › FRONT POWER SEAT CONTROL SYSTEM(w/ Memory)
RM27M0U _58 Vehicle Interior _049136 SEAT _0234304 FRONT POWER SEAT CONTROL SYSTEM(w/ Memory) J

SEAT  FRONT POWER SEAT CONTROL SYSTEM(w/ Memory)  Wireless-linked Return Function does not Operate  


DESCRIPTION

When a door is unlocked by the wireless unlock function, the main body ECU (driver side junction block assembly) receives the door unlock signal and it stores the key ID. When the driver door is opened, the memory call and memory command information of the stored key ID is sent to each driving position related control ECU. Each control ECU receives the memory commands and performs the memory call operation according to predetermined control timing values.

PROCEDURE

1.CHECK CAN COMMUNICATION SYSTEM
a.

Use the Techstream to check if the CAN communication system is functioning normally (See page Power Source / Network>CAN COMMUNICATION>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING).

OK:

CAN communication DTC is not output.




OK

2.CHECK FRONT POWER SEAT CONTROL SYSTEM

NG

2.CHECK FRONT POWER SEAT CONTROL SYSTEM
a.

b.

Check the seat position memory function (See page Vehicle Interior>SEAT>FRONT POWER SEAT CONTROL SYSTEM(w/ Memory)>OPERATION CHECK).


c.

Check the seat position restoring function (See page Vehicle Interior>SEAT>FRONT POWER SEAT CONTROL SYSTEM(w/ Memory)>OPERATION CHECK).


d.

Check the memory call registration function (See page Vehicle Interior>SEAT>FRONT POWER SEAT CONTROL SYSTEM(w/ Memory)>OPERATION CHECK).

Result
Result Proceed to
OK A
NG (power seat control function) B
NG (seat position memory function) C
NG (seat position restoring function) D
NG (memory call registration function) E



A

3.CHECK WIRELESS DOOR LOCK CONTROL SYSTEM

B

C

Go to OTHER FLOW CHART (Power Seat Position is not Memorized)

D

Go to OTHER FLOW CHART (Power Seat does not Return to Memorized Position)

E

Go to OTHER FLOW CHART (Wireless Transmitter Memory Function does not Operate)

3.CHECK WIRELESS DOOR LOCK CONTROL SYSTEM
a.

Check the wireless lock/unlock function of wireless door lock control system (See page Vehicle Interior>DOOR LOCK>WIRELESS DOOR LOCK CONTROL SYSTEM>OPERATION CHECK).

OK:

Wireless lock/unlock function operates normally.




OK

4.REPLACE POSITION CONTROL ECU AND SWITCH ASSEMBLY

NG

4.REPLACE POSITION CONTROL ECU AND SWITCH ASSEMBLY
a.

Temporarily replace the position control ECU and switch assembly with a new or normally functioning one (See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Power Seat)>DISASSEMBLY).



NEXT

5.CHECK MEMORY CALL FUNCTION
5.CHECK MEMORY CALL FUNCTION
a.

Perform a seat position memory function (See page Vehicle Interior>SEAT>FRONT POWER SEAT CONTROL SYSTEM(w/ Memory)>OPERATION CHECK).


b.

Perform a memory call registration function (See page Vehicle Interior>SEAT>FRONT POWER SEAT CONTROL SYSTEM(w/ Memory)>OPERATION CHECK).


c.

Turn the ignition switch off.


d.

Close and lock all doors.


e.

Unlock the driver door by pressing the unlock switch of the memory call registered key.


f.

Open the driver door and check that the driver seat moves to the memorized position (See page Vehicle Interior>SEAT>FRONT POWER SEAT CONTROL SYSTEM(w/ Memory)>OPERATION CHECK).

OK:

Driver seat moves to the memorized position.




OK

END (POSITION CONTROL ECU AND SWITCH ASSEMBLY WAS DEFECTIVE)

NG

REPLACE MAIN BODY ECU (DRIVER SIDE JUNCTION BLOCK ASSEMBLY)