Home › Engine / Hybrid System › 3UR-FBE CHARGING › GENERATOR
RM27M0U _51 Engine / Hybrid System _049148 3UR-FBE CHARGING _0234380 GENERATOR A

3UR-FBE CHARGING  GENERATOR  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 28800 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 17880 4.REMOVE AIR CLEANER HOSE ASSEMBLY

Hide 51441 6.REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

Hide 53736 8.REMOVE FRONT FENDER APRON SEAL RH

a.

Remove the 5 clips and apron seal.


Hide 44320 9.DISCONNECT VANE PUMP ASSEMBLY

Hide 27020 10.REMOVE GENERATOR ASSEMBLY

a.
A156405

Disconnect the generator connector.


b.

Remove the terminal cap and nut, and disconnect the generator wire.


c.

Remove the bolt and disconnect the wire harness bracket from the generator.


d.
A156406

Remove the 3 bolts, nut and generator.