Home › Engine / Hybrid System › 3UR-FBE STARTING › STARTER
RM27M0U _51 Engine / Hybrid System _049145 3UR-FBE STARTING _0234370 STARTER A

3UR-FBE STARTING  STARTER  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 11209 4.REMOVE V-BANK COVER SUB-ASSEMBLY

Hide 17880 5.REMOVE AIR CLEANER HOSE ASSEMBLY

Hide 53736 8.REMOVE FRONT FENDER APRON SEAL RH

Hide 44320 9.DISCONNECT VANE PUMP ASSEMBLY

a.
A164433

Detach the 2 clamps and disconnect the power steering oil pressure switch connector.


b.
A163289

Remove the 2 bolts and disconnect the vane pump.


Hide 27020 10.REMOVE GENERATOR ASSEMBLY

a.
A163292

Disconnect the generator connector.


b.

Remove the terminal cap and nut, and disconnect the generator wire.


c.
A379982

Remove the bolt and disconnect the wire harness bracket from the generator.


d.
A260951

Remove the 3 bolts, nut and generator.


Hide 11452 11.REMOVE ENGINE OIL LEVEL DIPSTICK GUIDE

a.

Remove the dipstick.


b.
A164432

Remove the bolt and dipstick guide.


c.

Remove the O-ring from the dipstick guide.


Hide 17410 12.REMOVE FRONT EXHAUST PIPE ASSEMBLY

a.

Disconnect the air fuel ratio sensor connector.


b.

Disconnect the heated oxygen sensor connector and detach the 2 clamps.


c.

Remove the 2 bolts.


d.

Remove the 3 nuts and front exhaust pipe.


e.

Remove the 2 gaskets.


Hide 17167 13.REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR

Hide 17104 14.REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY RH

Hide 28192 15.REMOVE STARTER COVER

a.
A162756

Remove the 3 bolts and starter cover.


Hide 28100 16.REMOVE STARTER ASSEMBLY

a.
A258301

Detach the 2 wire harness clamps.


b.

Disconnect the starter connector.


c.

Remove the nut and disconnect the starter wire.


d.
A258302

Remove the 2 bolts and starter.


e.
A162758

Remove the flywheel housing side cover.