A new skid control ECU is supplied without zero point calibration for the deceleration sensor and master cylinder pressure sensor. Until the zero points are calibrated, DTC C1336/39 remains stored. By entering test mode, the zero point calibration is automatically performed, and DTC C1336/39 is erased automatically.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1336/39 | When the vehicle is driven without completion of zero point calibration. | ·
Skid control ECU ·
Zero point calibration incomplete |
When replacing the VSC actuator assembly, perform the zero point calibration (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION).
When U0123/62, U0124/69 or U0126/63 is output together with C1336/39, inspect and repair trouble areas indicated by U0123/62, U0124/69 or U0126/63 first.
Perform the test mode procedure (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>TEST MODE PROCEDURE).
Check if any of the test mode DTCs are recorded.
| Result | Proceed to |
|---|---|
| DTC (test mode DTC) is not output | A |
| DTC (test mode DTC) is output | B |
A
B
Check that the yaw rate sensor has been installed properly (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>YAW RATE AND DECELERATION SENSOR>INSTALLATION).
The sensor is tightened to the specified torque.
The sensor is not tilted.
OK
NG
Perform zero point calibration of the deceleration sensor (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION).
NEXT
Clear the DTC (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR).
Start the engine.
Check if the same DTC is recorded (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC is output | A |
| DTC is not output | B |
The DTC is set if the zero point calibration has not been completed successfully.
End the procedure when the same DTC is not set after completion of the zero point calibration.
A
B
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)