1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
55301
3.REMOVE INSTRUMENT PANEL SUB-ASSEMBLY
for Column Shift Type:
(See page Vehicle Interior>INTERIOR PANEL>INSTRUMENT PANEL SAFETY PAD(for Column Shift Type)>REMOVAL)
for Floor Shift Type:
(See page Vehicle Interior>INTERIOR PANEL>INSTRUMENT PANEL SAFETY PAD(for Floor Shift Type)>REMOVAL)
55844
4.REMOVE NO. 2 HEATER TO REGISTER DUCT
55972C
5.REMOVE NO. 2 SIDE DEFROSTER NOZZLE DUCT
55971C
6.REMOVE NO. 1 SIDE DEFROSTER NOZZLE DUCT
55950G
7.REMOVE DEFROSTER NOZZLE ASSEMBLY
86860
8.REMOVE NAVIGATION ANTENNA ASSEMBLY
Detach the 2 clamps.
| *a | Guide | *b | Clamp |
Remove the 2 screws.
Detach the 2 guides and remove the navigation antenna assembly.