As the rear bumper cover is extremely heavy, the engine lifter may suddenly drop if the instructions listed in the repair manual are not followed. Therefore, always follow the instructions listed in the repair manual when performing this procedure.
89341B
1.INSTALL NO. 2 ULTRASONIC SENSOR (for Steel Type Bumper)
Install the No. 2 ultrasonic sensor as shown in the illustration.
Do not damage the bumper with the protrusion when installing the No. 2 ultrasonic sensor.
89348A
2.INSTALL NO. 2 ULTRASONIC SENSOR RETAINER (for Steel Type Bumper)
Install the No. 2 ultrasonic sensor retainer as shown in the illustration.
89341B
3.INSTALL NO. 2 ULTRASONIC SENSOR (for Resin Type Bumper)
Attach the 4 claws to install the No. 2 ultrasonic sensor as shown in the illustration.
| *a | No. 2 ultrasonic sensor direction |
| *b | Keyhole direction |
No. 2 ultrasonic sensor direction is the same as the keyhole direction.
Do not damage the bumper with the protrusion when installing the No. 2 ultrasonic sensor.
89341C
4.INSTALL NO. 3 ULTRASONIC SENSOR
Attach the 4 claws to install the No. 3 ultrasonic sensor as shown in the illustration.
| *a | No. 3 ultrasonic sensor direction |
| *b | Keyhole direction |
No. 3 ultrasonic sensor direction is the same as the keyhole direction.
Do not damage the bumper with the protrusion when installing the No. 3 ultrasonic sensor.
82165
5.INSTALL NO. 2 FRAME WIRE (for Steel Type Bumper)
52179A
6.INSTALL REAR BUMPER BAR CORNER REINFORCEMENT LH (for Steel Type Bumper)
52178A
7.INSTALL REAR BUMPER BAR CORNER REINFORCEMENT RH (for Steel Type Bumper)
52156E
8.INSTALL REAR BUMPER EXTENSION INSERT LH (for Resin Type Bumper)
52155E
9.INSTALL REAR BUMPER EXTENSION INSERT RH (for Resin Type Bumper)
81690A
10.INSTALL LICENSE PLATE LIGHT ASSEMBLY LH
81270D
11.INSTALL LICENSE PLATE LIGHT ASSEMBLY RH
Use the same procedure described for the LH side.
52057
12.INSTALL REAR BUMPER PAD SUB-ASSEMBLY (for Steel Type Bumper)
52057
13.INSTALL REAR BUMPER PAD SUB-ASSEMBLY (for Resin Type Bumper)
52164A
14.INSTALL REAR BUMPER PLATE LH (for Steel Type Bumper)
52164A
15.INSTALL REAR BUMPER PLATE LH (for Resin Type Bumper)
52163A
16.INSTALL REAR BUMPER PLATE RH (for Steel Type Bumper)
52163A
17.INSTALL REAR BUMPER PLATE RH (for Resin Type Bumper)
18.INSTALL REAR BUMPER COVER (for Steel Type Bumper)
19.INSTALL REAR BUMPER COVER (for Resin Type Bumper)
82824X
20.INSTALL WIRING HARNESS CONNECTOR (for Steel Type Bumper)
82824X
21.INSTALL WIRING HARNESS CONNECTOR (for Resin Type Bumper)
82821A
22.INSTALL CONNECTOR COVER (for Steel Type Bumper)
82821A
23.INSTALL CONNECTOR COVER (for Resin Type Bumper)