If the AUTO UP/DOWN function does not operate, the cause may be one or more of the following:
The ECU in the driver side motor determines that the driver side motor has not been initialized.
The master switch has a malfunction.
The Hall-IC in the driver side motor has a malfunction.
The wiring between the master switch and the driver side motor is open or shorted.
Check for DTCs (See page Vehicle Interior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM(w/ Jam Protection Function)>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC is not output | A |
| DTC B2311 is output | B |
| DTC B2312 is output | C |
| DTC B2313 is output | D |
| LIN communication system DTCs are output | E |
A
B
(See pageVehicle Interior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM(w/ Jam Protection Function)>B2311)
C
(See pageVehicle Interior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM(w/ Jam Protection Function)>B2312)
D
(See pageVehicle Interior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM(w/ Jam Protection Function)>B2313)
E
Check that the manual UP/DOWN function using the master switch can operate the driver side power window (See page Vehicle Interior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM(w/ Jam Protection Function)>OPERATION CHECK).
Manual UP/DOWN function operates normally.
OK
NG
Use the Data List to check if the master switch is functioning properly.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| D Door P/W Auto SW | Driver side power window auto UP/ DOWN switch signal / ON or OFF | ON: Driver side switch operated
OFF: Driver side switch not operated |
- |
The Techstream display changes normally when master switch is operated.
OK
NG