| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | REAR AXLE HUB AND BEARING ASSEMBLY | 42450B | - | - | - |
| 2 | NO. 2 PARKING BRAKE WIRE ASSEMBLY | 890C0A | - | - | - |
| 3 | NO. 1 PARKING BRAKE WIRE ASSEMBLY | 890C0 | - | - | - |
| *A | for LH Side | *B | for RH Side |
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the rear coil spring removal/installation are shown below.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
1.REMOVE REAR AXLE HUB AND BEARING ASSEMBLY
890C0A
2.SEPARATE NO. 2 PARKING BRAKE WIRE ASSEMBLY (for LH Side)
890C0
3.SEPARATE NO. 1 PARKING BRAKE WIRE ASSEMBLY (for RH Side)
48790
4.REMOVE REAR UPPER CONTROL ARM ASSEMBLY
48730
5.REMOVE LOWER CONTROL ARM ASSEMBLY
48540
6.DISCONNECT REAR SHOCK ABSORBER ASSEMBLY
Support the spring seat of the rear No. 1 suspension arm assembly using jack and wooden block.
Do not jack up the rear No. 1 suspension arm assembly too high as the vehicle may fall.
Remove the bolt and separate the rear No. 1 suspension arm assembly from the rear shock absorber assembly.
48231B
7.REMOVE REAR COIL SPRING
Slowly lower the rear No. 1 suspension arm assembly using jacks and wooden block, and remove the rear coil spring.
48259A
8.REMOVE REAR UPPER COIL SPRING INSULATOR
48258C
9.REMOVE REAR LOWER COIL SPRING INSULATOR