|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) |
|
N*m (kgf*cm, ft.*lbf): Specified torque |
| * | For use with union nut wrench | ● | Non-reusable part |
|
MP Grease | - | - |
|
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
31410
1.INSTALL CLUTCH MASTER CYLINDER ASSEMBLY
55606
4.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
31481
5.CONNECT CLUTCH MASTER CYLINDER TO FLEXIBLE HOSE TUBE
|
|
| *a | Torque Wrench Fulcrum Length | - | - |
Using a 10 mm union nut wrench, connect the clutch master cylinder to flexible hose tube to the clutch master cylinder assembly.
Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
When using a union nut wrench (fulcrum length of 22 mm (0.866 in.)) + torque wrench (fulcrum length of 162 mm (6.38 in.)):
13.4 N*m (137 kgf*cm, 10 ft.*lbf)
31434E
6.CONNECT NO. 1 CLUTCH RESERVOIR HOSE
|
|
| *a | View A | *b | Top of Vehicle |
| *c | Paint Mark (Front of Vehicle) | *d | 0 to 2 mm (0 to 0.0787 in.) |
Connect the No. 1 clutch reservoir hose to the clutch master cylinder assembly and slide the hose clip to secure it.
7.BLEED CLUTCH LINE
Click hereDrivetrain>CLUTCH>CLUTCH SYSTEM>BLEEDING
8.INSPECT FOR BRAKE FLUID LEAK
9.INSPECT BRAKE FLUID LEVEL IN RESERVOIR
55701J
10.INSTALL OUTER COWL TOP PANEL SUB-ASSEMBLY
55815E
11.INSTALL FRONT NO. 1 VENTILATOR SEAL
55735A
12.INSTALL WATER GUARD PLATE LH
13.INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY
14.INSPECT CLUTCH PEDAL