|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) | - | - |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 5 | REAR UPPER CONTROL ARM ASSEMBLY LH | 48790 | - | - | - |
| 6 | REAR UPPER CONTROL ARM ASSEMBLY RH | 48770A | - | - | - |
| 7 | LOWER CONTROL ARM ASSEMBLY LH | 48730 | - | - | - |
| 8 | LOWER CONTROL ARM ASSEMBLY RH | 48720 | - | - | - |
| 9 | REAR TRACTION MOTOR WITH TRANSAXLE ASSEMBLY | G1050 | - | - | - |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 10 | FRONT EXHAUST PIPE ASSEMBLY | 17410 | ( )
|
- | - |
| 11 | REAR WHEEL | - | - | - | - |
|
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
| *1 | CAMBER ADJUST CAM SUB-ASSEMBLY | *2 | REAR NO. 2 SUSPENSION TOE ADJUST PLATE |
|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) | - | - |
890C0A
1.INSTALL NO. 2 PARKING BRAKE WIRE ASSEMBLY
51206A
2.INSTALL REAR SUSPENSION MEMBER SUB-ASSEMBLY
|
|
Using a transmission jack and a wooden block or equivalent tools, support the rear suspension member sub-assembly as shown in the illustration.
Raise the rear suspension member sub-assembly until there is no clearance between the rear suspension member sub-assembly and vehicle.
Install the rear suspension member sub-assembly with the 2 bolts and 2 nuts.
890C0A
3.CONNECT NO. 2 PARKING BRAKE WIRE ASSEMBLY
48790
5.INSTALL REAR UPPER CONTROL ARM ASSEMBLY LH
48770A
6.INSTALL REAR UPPER CONTROL ARM ASSEMBLY RH
48730
7.INSTALL LOWER CONTROL ARM ASSEMBLY LH
48720
8.INSTALL LOWER CONTROL ARM ASSEMBLY RH
G1050
9.INSTALL REAR TRACTION MOTOR WITH TRANSAXLE ASSEMBLY
11.INSTALL REAR WHEEL
12. STABILIZE SUSPENSION
48720
14.FULLY TIGHTEN LOWER CONTROL ARM ASSEMBLY RH
48770A
16.FULLY TIGHTEN REAR UPPER CONTROL ARM ASSEMBLY RH
17.INSPECT AND ADJUST REAR WHEEL ALIGNMENT
18.PERFORM INITIALIZATION
19. CHECK FOR SPEED SENSOR SIGNAL
for HV Model TMC Made:
for HV Model TMMF Made:
20.INSPECT FOR EXHAUST GAS LEAK