Home › Engine / Hybrid System › 2NZ-FE COOLING › WATER PUMP
RM19S0E _51 Engine / Hybrid System _051459 2NZ-FE COOLING _0248131 WATER PUMP A

2NZ-FE COOLING  WATER PUMP  INSTALLATION  


PROCEDURE

Hide 16100 1.INSTALL WATER PUMP ASSEMBLY

a.

Install the water pump assembly through a new water pump gasket with the 3 bolts and 2 nuts.

Torque:
11 N*m (112 kgf*cm, 8 ft.*lbf)


Hide 16173 2.INSTALL WATER PUMP PULLEY

a.

Temporarily install the water pump pulley with the 3 bolts.


b.

Using SST, hold the water pump pulley.

SST
09960-10010  (09962-01000, 09963-00700)


c.

Tighten the 3 bolts to the specified torque.

Torque:
15 N*m (153 kgf*cm, 11 ft.*lbf)


Hide 12305 3.INSTALL ENGINE MOUNTING INSULATOR SUB-ASSEMBLY RH

Hide 8.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)

Hide 51441C 11.INSTALL ENGINE UNDER COVER RH

a.

Install the engine under cover RH with the 3 screws and 2 bolts.

Torque:
5.0 N*m (51 kgf*cm, 44 in.*lbf)