Home › Drivetrain › CLUTCH › CLUTCH MASTER CYLINDER(for RHD)
RM19S0E _52 Drivetrain _051467 CLUTCH _0248189 CLUTCH MASTER CYLINDER(for RHD) A

CLUTCH  CLUTCH MASTER CYLINDER(for RHD)  REMOVAL  


PROCEDURE

Hide 55606 1.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/o Knee Airbag)

HINT:

Use the same procedure as for LHD models (See page Vehicle Interior>INTERIOR PANELS / TRIM>LOWER INSTRUMENT PANEL>REMOVAL).


Hide 55432B 2.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL (w/o Knee Airbag)

Hide 73900 3.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (w/ Knee Airbag)

HINT:

Use the same procedure as for LHD models (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>KNEE AIRBAG ASSEMBLY>REMOVAL).


Hide 4.REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY

HINT:

Use the same procedure as for LHD models (See page Vehicle Exterior>WIPER / WASHER>FRONT WIPER MOTOR>REMOVAL).


Hide 55815E 5.REMOVE FRONT NO. 1 VENTILATOR SEAL

Hide 55735D 6.REMOVE FRONT AIR SHUTTER SEAL RH

Hide 55722C 7.REMOVE INNER COWL TOP TO COWL BRACE

Hide 55711 8.REMOVE OUTER COWL TOP PANEL

Hide 9.DRAIN BRAKE FLUID

Hide 31434 10.DISCONNECT CLUTCH RESERVOIR TUBE

a.
C235141

Slide the clip and disconnect the clutch reservoir tube from the clutch master cylinder assembly.

HINT:

Use container to collect the fluid.



Hide 31481 11.DISCONNECT CLUTCH MASTER CYLINDER TO FLEXIBLE HOSE TUBE

a.
C235142

Using a union nut wrench (10 mm), disconnect the clutch master cylinder to flexible hose tube from the clutch master cylinder assembly.

HINT:

Use container to collect the fluid.



Hide 31410 12.REMOVE CLUTCH MASTER CYLINDER ASSEMBLY

a.
C235126

Remove the clip and the clevis pin, and separate the clutch master cylinder push rod clevis from the clutch pedal sub-assembly.


b.
C235127

Remove the 2 nuts and the clutch master cylinder assembly.


Hide 31453 13.REMOVE CLUTCH MASTER CYLINDER PUSH ROD CLEVIS

a.
C235814E02
1.17,1.674 1.28,1.813 0.11,0.139 10 A 1.007,0.407 1.158,0.559 0.152,0.152 10 *1 2.609,0.208 2.76,0.359 0.152,0.152 10 *2 1.196,0.502 1.635,0.943 false 2.145,0.727 2.571,0.299 false

Measure the dimension A as shown in the illustration before loosening the lock nut.

Text in Illustration
*1 Lock Nut
*2 Clutch Master Cylinder Push Rod Clevis


b.

Loosen the lock nut and remove the clutch master cylinder push rod clevis from the push rod.


c.

Remove the lock nut from the push rod.