Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ANTI-LOCK BRAKE SYSTEM › 2011.08–2014.07
RM19S0E _54 Brake _051475 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0248226 ANTI-LOCK BRAKE SYSTEM C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ANTI-LOCK BRAKE SYSTEM  C1203  ECM Communication Circuit Malfunction  


DESCRIPTION

The circuit is used to send vehicle information from the main body ECU (multiplex network body ECU) to the skid control ECU (brake actuator assembly) through the CAN communication system.

DTC No. DTC Detection Condition Trouble Area
C1203 Engine, drive source and destination variations that are sent from the ECM or main body ECU (multiplex network body ECU) do not match the ones of the skid control ECU (brake actuator assembly).
·

ECM

·

Main body ECU (Multiplex network body ECU)

·

Skid control ECU (Brake actuator assembly)



PROCEDURE

1.CHECK PART NUMBER (ECM)
a.

Check that the proper ECM is installed.


Result
Result Proceed to
Proper ECM is installed A
Proper ECM are not installed (for 1NZ-FE) B
Proper ECM are not installed (for 2NZ-FE) C


A

2.CHECK PART NUMBER (MAIN BODY ECU)

B

C

2.CHECK PART NUMBER (MAIN BODY ECU)
a.

Check that the proper main body ECU (multiplex network body ECU) is installed.

Result
Result Proceed to
Proper ECU is installed A
Proper ECU is not installed B



A

3.CHECK BRAKE ACTUATOR ASSEMBLY (SKID CONTROL ECU)

B

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)

3.CHECK BRAKE ACTUATOR ASSEMBLY (SKID CONTROL ECU)
a.

Check if the skid control ECU (brake actuator assembly) had been replaced before the DTC was recorded.

Result
Result Proceed to
The brake actuator assembly is not replaced A
The brake actuator assembly is replaced B



A

4.RECONFIRM DTC

B

5.PERFORM TEST MODE PROCEDURE
4.RECONFIRM DTC


Result
Result Proceed to
DTC is not output A
DTC is output (for LHD) B
DTC is output (for RHD) C


A

B

C

5.PERFORM TEST MODE PROCEDURE

NEXT

6.RECONFIRM DTC
6.RECONFIRM DTC


Result
Result Proceed to
DTC is not output A
DTC is output (for LHD) B
DTC is output (for RHD) C


A

END

B

C