Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM › 2011.08–2014.07
RM19S0E _58 Vehicle Interior _051493 METER / GAUGE / DISPLAY _0248310 METER / GAUGE SYSTEM J

METER / GAUGE / DISPLAY  METER / GAUGE SYSTEM  Tachometer Malfunction  


DESCRIPTION

In this circuit, the meter CPU receives engine speed signals from the ECM using the CAN communication system (CAN V1 Bus). The meter CPU displays the engine speed calculated based on the data received from the ECM.

WIRING DIAGRAM

E346310E03
0.563,3.146 1,3.344 0.438,0.198 10 false ECM 2.927,3.219 4.688,3.427 1.76,0.208 10 false : CAN Communication Line 5.292,3.156 7.156,3.354 1.865,0.198 10 false Combination Meter Assembly

PROCEDURE

1.CHECK CAN COMMUNICATION SYSTEM
a.

Check if a CAN communication DTC is output.



Result
Result Proceed to
CAN communication DTC is not output A
CAN communication DTC is output (except Separate Type Yaw Rate Sensor) B
CAN communication DTC is output (for Separate Type Yaw Rate Sensor) C



A

2.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (TACHOMETER OPERATION)

B

C

2.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (TACHOMETER OPERATION)
a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the intelligent tester on.


d.

Enter the following menus: Body / Combination Meter / Active Test.


e.

According to the display on the intelligent tester, perform the Active Test.

Combination Meter
Tester Display Test Part Control Range Diagnostic Note
TachoMeter Operation Tachometer OFF/0/1000/2000/3000/4000/5000/6000/7000 rpm Perform the test with the vehicle stopped and the engine idling.

OK:

Tachometer indication is normal.




OK

3.READ VALUE USING INTELLIGENT TESTER (ENGINE RPM)

NG

REPLACE COMBINATION METER ASSEMBLY

3.READ VALUE USING INTELLIGENT TESTER (ENGINE RPM)
a.

Connect the intelligent tester to the DLC3.


b.

Start the engine.


c.

Turn the intelligent tester on.


d.

Enter the following menus: Body / Combination Meter / Data List.


e.

According to the display on the intelligent tester, read the Data List.

Combination Meter
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
Engine Rpm Engine speed/
Min.: 0
Max.: 12750
Approximately same as actual engine speed (when engine is running) Unit: rpm

OK:

Engine speed displayed on the intelligent tester is almost the same as the tachometer indication.


HINT:

Check the engine speed when the engine is fully warmed up, and the air conditioning and all electrical accessories are off.




OK

4.CHECK ENGINE CONTROL SYSTEM

NG

REPLACE COMBINATION METER ASSEMBLY

4.CHECK ENGINE CONTROL SYSTEM
a.

Check if a engine control DTC is output.


Result
Result Proceed to
Engine control DTC is not output A
Engine control DTC is output (for 2NZ-FE) B
Engine control DTC is output (for 1NZ-FE) C



A

REPLACE COMBINATION METER ASSEMBLY

B

C