Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System) › 2011.08–2014.07
RM19S0E _58 Vehicle Interior _051498 HEATING / AIR CONDITIONING _0248350 AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System) Y

HEATING / AIR CONDITIONING  AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System)  HOW TO PROCEED WITH TROUBLESHOOTING  


CAUTION / NOTICE / HINT

HINT:
·

Use these procedures to troubleshoot the air conditioning system.

·

*: Use the intelligent tester.



PROCEDURE

1.VEHICLE BROUGHT TO WORKSHOP
Result:
Proceed to
NEXT



NEXT

2.INSPECT BATTERY VOLTAGE
2.INSPECT BATTERY VOLTAGE
Standard voltage:

11 to 14 V


If the voltage is below 11 V, recharge or replace the battery before proceeding.

Result:
Proceed to
NEXT



NEXT

3.CHECK LIN COMMUNICATION SYSTEM*
3.CHECK LIN COMMUNICATION SYSTEM*
a.

Use the intelligent tester to check if the LIN communication system is functioning.


Result:
Result Proceed to
LIN DTC is not output A
LIN DTC is output B



A

4.CHECK CAN COMMUNICATION SYSTEM*

B

4.CHECK CAN COMMUNICATION SYSTEM*
a.

Use the intelligent tester to check if the CAN communication system is functioning.


Result:
Result Proceed to
CAN DTC is not output A
CAN DTC is output (except Separate Type Yaw Rate Sensor) B
CAN DTC is output (for Separate Type Yaw Rate Sensor) C



A

5.CHECK DTCs OR CHECK SENSOR CHECK CODES THROUGH PANEL DIAGNOSIS

B

C

5.CHECK DTCs OR CHECK SENSOR CHECK CODES THROUGH PANEL DIAGNOSIS
a.

Check DTCs or sensor check codes.

i.

Write down the DTCs or sensor check codes.



b.

Clear the DTCs or sensor check codes.


c.

Check whether the DTCs or sensor check codes recur.

i.

Reproduce the problem symptoms in accordance with the DTCs or sensor check codes that were written down, and check whether the DTCs or sensor check codes recur.

HINT:

Refer to the DTC chart when any DTCs or sensor check codes are output.




Result:
Result Proceed to
DTC or sensor check code is not output A
DTC or sensor check code is output B



A

6.REFER TO PROBLEM SYMPTOMS TABLE

B

8.ADJUST, REPAIR OR REPLACE
6.REFER TO PROBLEM SYMPTOMS TABLE

Result:
Result Proceed to
Fault not listed in Problem Symptoms Table A
Fault listed in Problem Symptoms Table B



A

7.OVERALL ANALYSIS AND TROUBLESHOOTING*

B

8.ADJUST, REPAIR OR REPLACE
7.OVERALL ANALYSIS AND TROUBLESHOOTING*

NEXT

8.ADJUST, REPAIR OR REPLACE
8.ADJUST, REPAIR OR REPLACE
Result:
Proceed to
NEXT



NEXT

9.CONFIRMATION TEST
9.CONFIRMATION TEST
Result:
Proceed to
NEXT



NEXT

END