Use these procedures to troubleshoot the air conditioning system.
*: Use the intelligent tester.
| Proceed to |
|---|
| NEXT |
NEXT
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
| Proceed to |
|---|
| NEXT |
NEXT
Use the intelligent tester to check if the LIN communication system is functioning.
| Result | Proceed to |
|---|---|
| LIN DTC is not output | A |
| LIN DTC is output | B |
A
B
Click herePower Source / Network>NETWORKING>LIN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
Use the intelligent tester to check if the CAN communication system is functioning.
| Result | Proceed to |
|---|---|
| CAN DTC is not output | A |
| CAN DTC is output (except Separate Type Yaw Rate Sensor) | B |
| CAN DTC is output (for Separate Type Yaw Rate Sensor) | C |
A
B
C
Check DTCs or sensor check codes.
Write down the DTCs or sensor check codes.
Clear the DTCs or sensor check codes.
Check whether the DTCs or sensor check codes recur.
Reproduce the problem symptoms in accordance with the DTCs or sensor check codes that were written down, and check whether the DTCs or sensor check codes recur.
Refer to the DTC chart when any DTCs or sensor check codes are output.
| Result | Proceed to |
|---|---|
| DTC or sensor check code is not output | A |
| DTC or sensor check code is output | B |
A
B
Refer to Problem Symptoms Table.
| Result | Proceed to |
|---|---|
| Fault not listed in Problem Symptoms Table | A |
| Fault listed in Problem Symptoms Table | B |
A
B
Diagnosis system
Panel diagnosis (indicator check)
Panel diagnosis (actuator check)
Panel diagnosis (refrigerant shortage check)
On-Vehicle Inspection
Inspection
Check for DTCs after checking harness and connector
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT