The MIL (Malfunction Indicator Lamp) is used to indicate vehicle malfunctions detected by the ECM.
When the ignition switch is turned to ON, power is supplied to the MIL circuit, and the ECM provides the circuit ground, which illuminates the MIL.
The MIL operation can be checked visually. When the ignition switch is first turned to ON, the MIL should be illuminated and should then turn off when the engine is started. If the MIL remains illuminated or is not illuminated, conduct the following troubleshooting procedure using the GTS.
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
Perform troubleshooting in accordance with the table below.
| Result | Proceed to |
|---|---|
| MIL remains on | A |
| MIL does not illuminate | B |
A
B
Connect the GTS to the DLC3.
Turn the ignition switch to ON and turn the GTS on.
Check if DTCs have been stored. If DTCs are present, write them down.
Clear DTCs (See page Engine / Hybrid System>1NZ-FE ENGINE CONTROL>1NZ-FE SFI SYSTEM>DTC CHECK / CLEAR).
Check that the MIL turns off.
MIL turns off.
OK
NG
| *a | Front view of wire harness connector
(to ECM) |
Disconnect the ECM connector.
Turn the ignition switch to ON.
Check that MIL is not illuminated.
MIL is not illuminated.
OK
NG
Disconnect the A83 ECM connector.
Disconnect the F1 combination meter assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F1-11 (CHK) or A83-27 (W) - Body ground | Always | 10 kΩ or higher |
OK
(See pageVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING)
NG
Check if the MIL is illuminates when the ignition switch is turned to ON.
MIL is illuminated.
OK
(See pageEngine / Hybrid System>1NZ-FE ENGINE CONTROL>1NZ-FE SFI SYSTEM>CHECK FOR INTERMITTENT PROBLEMS)
NG
Turn the ignition switch to ON.
Start the engine.
| Result | Proceed to |
|---|---|
| Engine starts | A |
| Engine does not start * | B |
*: The GTS cannot communicate with the ECM.
A
B
Disconnect the A83 ECM connector.
Disconnect the F1 combination meter assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F1-11 (CHK) - A83-27 (W) | Always | Below 1 Ω |
OK
NG