Home › Vehicle Interior › PRE-CRASH SAFETY › PRE-CRASH SAFETY SYSTEM › from 2017.01
RM19S0E _58 Vehicle Interior _063185 PRE-CRASH SAFETY _0307822 PRE-CRASH SAFETY SYSTEM C

PRE-CRASH SAFETY  PRE-CRASH SAFETY SYSTEM  C1AAA  FCM Destination Information Uninitialized  


DESCRIPTION

When a new pre-crash safety city sensor is installed, it receives and stores vehicle destination information from the main body ECU (multiplex network body ECU). If the pre-crash safety city sensor cannot receive vehicle destination information from the main body ECU (multiplex network body ECU) and vehicle information is not stored, DTC C1AAA is output.

DTC Code DTC Detection Condition Trouble Area
C1AAA

All of the following conditions are met:

-

The battery voltage is 10 V or more.

-

The vehicle is being driven at 50 km/h (32 mph) or more.

-

Destination information has not been stored in the pre-crash safety city sensor.



·

Main Body ECU (multiplex network body ECU)

·

Pre-crash safety city sensor



CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the pre-crash safety city sensor, replace it with a new one. If an ECU which was installed to another vehicle is used, the information stored in the pre-crash safety city sensor will not match the information from the vehicle and, as a result, a DTC may be output.

·

If the pre-crash safety city sensor has been replaced, or the windshield glass has been replaced or removed/installed, be sure to perform Recognition Camera/Target Position Memory and Recognition Camera Axis Adjust.

·

Perform adjustment using "ONE TIME RECOGNITION" or "SEQUENTIAL RECOGNITION".

·

First check the CAN communication system by following How to Proceed with Troubleshooting. After checking that there are no malfunctions in the CAN communication system, proceed to troubleshooting (See page Vehicle Interior>PRE-CRASH SAFETY>PRE-CRASH SAFETY SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING).



PROCEDURE

1.CHECK FOR DTCs

b.

Perform the following procedure.

HINT:

If the following procedure is not performed, the previously output DTC cannot be detected.

1.

Drive the vehicle at a speed of 50 km/h (32 mph) or more for 1 second or more.




c.

Check for DTCs (See page Vehicle Interior>PRE-CRASH SAFETY>PRE-CRASH SAFETY SYSTEM>DTC CHECK / CLEAR).

Result
Result Proceed to
DTC C1AAA is not output A
DTC C1AAA is output B



A

B

2.REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)
2.REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)
a.

Replace the main body ECU (multiplex network body ECU) with a new one (See pagePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU>REMOVAL).



NEXT

3.CHECK FOR DTCs
3.CHECK FOR DTCs

b.

Make sure that the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the system cannot detect the malfunction.



c.

Check for DTCs (See page Vehicle Interior>PRE-CRASH SAFETY>PRE-CRASH SAFETY SYSTEM>DTC CHECK / CLEAR).

Result
Result Proceed to
DTC C1AAA is not output A
DTC C1AAA is output B



A

END (MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) WAS DEFECTIVE)

B

REPLACE PRE-CRASH SAFETY CITY SENSOR