Steering angle sensor signals are sent to the skid control ECU (brake actuator assembly) via the CAN communication system. When there is a malfunction in the CAN communication system, it will be detected by the steering angle sensor zero point malfunction diagnostic function.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1434 | Normal communication between the skid control ECU and the steering angle sensor and abnormal steering angle sensor zero point. | ·
Steering angle sensor power supply ·
Steering angle sensor (Spiral cable sub-assembly) ·
Skid control ECU (Brake actuator assembly) |
Refer to DTC C1432 (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM(for Built-in Type Yaw Rate Sensor)>C1432).
Do not remove the steering sensor from the spiral cable.
When replacing the spiral cable sub-assembly, confirm that the replacement part is of the correct specification.
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
When U0073, U0124 and/or U0126 is output together with C1434, inspect and repair the trouble areas indicated by U0073, U0124 and/or U0126 first (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM(for Built-in Type Yaw Rate Sensor)>U0073).
When any of the speed sensors or the yaw rate and deceleration sensor (airbag sensor assembly) has trouble, DTCs for the steering angle sensor (spiral cable sub-assembly) may be output even when the steering angle sensor (spiral cable sub-assembly) is normal. When DTCs for the speed sensors or yaw rate and deceleration sensor (airbag sensor assembly) are output together with DTCs for the steering angle sensor (spiral cable sub-assembly), inspect and repair the speed sensor and yaw rate and deceleration sensor (airbag sensor assembly) first, and then inspect and repair the steering angle sensor (spiral cable sub-assembly).
Turn the ignition switch off.
Turn the ignition switch to ON again and check that no CAN communication system DTC is output.
w/o Toyota Safety Sense: See pagePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(w/o Toyota Safety Sense)>DIAGNOSIS SYSTEM
w/ Toyota Safety Sense: See pagePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(w/ Toyota Safety Sense)>DIAGNOSIS SYSTEM
Start the engine.
Drive the vehicle and turn the steering wheel to the right and left at a speed of 35 km/h (22 mph) and check that no speed sensor or yaw rate and acceleration sensor DTCs are output (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM(for Built-in Type Yaw Rate Sensor)>DIAGNOSTIC TROUBLE CODE CHART).
| Result | Proceed to |
|---|---|
| No CAN communication system, speed sensor, or yaw rate and acceleration sensor DTCs are output | A |
| CAN communication system DTC is output (w/o Toyota Safety Sense) | B |
| CAN communication system DTC is output (w/ Toyota Safety Sense) | C |
| Speed sensor or yaw rate and acceleration sensor DTC is output | D |
If there is a malfunction in any of the speed sensors or the yaw rate and deceleration sensor (airbag sensor assembly), an abnormal value may be output although the steering angle sensor (spiral cable sub-assembly) sensor is normal.
If speed sensor and yaw rate and deceleration sensor (airbag sensor assembly) DTCs are output simultaneously, repair these two sensors first and inspect the steering angle sensor (spiral cable sub-assembly).
A
B
C
D
OK
NG
OK
NG
OK
NG