Home › Drivetrain › C54 MANUAL TRANSMISSION / TRANSAXLE › MANUAL TRANSAXLE SYSTEM(for 2NZ-FE) › 2013.08–2016.10
RM30M0E _52 Drivetrain _017091 C54 MANUAL TRANSMISSION / TRANSAXLE _0094347 MANUAL TRANSAXLE SYSTEM(for 2NZ-FE) T

C54 MANUAL TRANSMISSION / TRANSAXLE  MANUAL TRANSAXLE SYSTEM(for 2NZ-FE)  PROBLEM SYMPTOMS TABLE  


HINT:

Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.


Manual Transaxle System
Symptom Suspected Area Link
Abnormal noise Oil level (Low) Click here
Oil (Wrong) Click here
Gear (Input shaft) (Worn or damaged) Click here
Gear (Output shaft) (Worn or damaged) Click here
Bearing (Input shaft) (Worn or damaged) Click here
Bearing (Output shaft) (Worn or damaged) Click here
Bearing (Differential case) (Worn or damaged) Click here
Oil leak Oil level (High) Click here
Gasket (Damaged) Click here
Oil seal (Worn or damaged) Click here
Hard shifting or impossible to shift Control cable (Faulty) Click here
Shift fork (Worn) Click here
Synchronizer ring (Input shaft) (Worn or damaged) Click here
Synchronizer ring (Output shaft) (Worn or damaged) Click here
Shift key spring (Input shaft) (Damaged) Click here
Shift key spring (Output shaft) (Damaged) Click here
Gear (Input shaft) (Damaged) Click here
Gear (Output shaft) (Damaged) Click here
Hub sleeve (Input shaft) (Damaged) Click here
Hub sleeve (Output shaft) (Damaged) Click here
Jumps out of gear or shift lever moves excessively Shift fork (Worn) Click here
Gear (Input shaft) (Worn or damaged) Click here
Gear (Output shaft) (Worn or damaged) Click here
Bearing (Input shaft) (Worn or damaged) Click here
Bearing (Output shaft) (Worn or damaged) Click here