Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
45879A
1.INSTALL BREAK AWAY CAPSULE
Install 2 new break away capsules to the steering column assembly.
2.INSTALL STEERING COLUMN ASSEMBLY
Install the steering column assembly to the instrument panel reinforcement assembly with the bolt and 2 nuts.
Engage the wire harness clamp to install the wire harness to the instrument panel reinforcement assembly.
Connect the 2 connectors to the power steering ECU assembly.
Connect all the connectors and engage all the wire harness clamps to the steering column assembly.
55106
3.INSTALL BRAKE PEDAL SUPPORT SUB-ASSEMBLY (for LHD)
55106
4.INSTALL BRAKE PEDAL SUPPORT SUB-ASSEMBLY (for RHD)
45209
5.INSTALL STEERING SLIDING YOKE SUB-ASSEMBLY
| *a | Matchmark |
Align the matchmarks on the steering sliding yoke sub-assembly and steering link assembly.
Install the steering sliding yoke sub-assembly to the steering link assembly.
Install bolt B.
Tighten bolt A.
45259A
6.INSTALL COLUMN HOLE COVER SILENCER SHEET
Install the column hole cover silencer sheet with the 2 clips.
55432B
7.INSTALL LOWER INSTRUMENT PANEL FINISH PANEL (for LHD)
55432B
8.INSTALL LOWER INSTRUMENT PANEL FINISH PANEL (for RHD)
55606
9.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
10.INSTALL COMBINATION SWITCH ASSEMBLY WITH SPIRAL CABLE
Using pliers, pinch the clamp and attach the claw to install the combination switch assembly with spiral cable to the steering column assembly.
Connect all the connectors to the combination switch assembly with spiral cable.
45286B
11.INSTALL UPPER STEERING COLUMN COVER
Engage the claw to install the upper steering column cover.
45287
12.INSTALL LOWER STEERING COLUMN COVER
Engage the 3 claws to install the lower steering column cover.
Install the 3 screws.
45289A
13.INSTALL STEERING COLUMN COVER SUPPORT (w/ Smart Entry and Start System)
Engage the 4 claws to install the steering column cover support.
14.PLACE FRONT WHEELS FACING STRAIGHT AHEAD
84306
15.ADJUST SPIRAL CABLE SUB-ASSEMBLY
45100
16.INSTALL STEERING WHEEL ASSEMBLY
45130
17.INSTALL HORN BUTTON ASSEMBLY (w/ Airbag System)
45130
18.INSTALL HORN BUTTON ASSEMBLY (w/o Airbag System)
45186
19.INSTALL NO. 2 STEERING WHEEL LOWER COVER
20.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
21.INSPECT SRS WARNING LIGHT
22. PERFORM CALIBRATION OF TORQUE SENSOR ZERO POINT