33820B
1.INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY
Install the transmission control cable assembly to the body with the 3 nuts.
| *a | Paint Mark |
Install the transmission control cable assembly to the No. 1 transmission control cable bracket with 2 new clips B.
Make sure that the paint marks on the transmission control cable assembly are aligned with the slits in the No. 1 transmission control cable bracket before installing the clips.
Connect the transmission control cable assembly to the manual transaxle assembly with the 2 washers and 2 clips A.
| *1 | Nut |
| *2 | Lock |
|
Rotate approximately 180° |
|
Push in |
Rotate the 2 nuts of the transmission control cable assembly approximately 180° in the direction shown in the illustration, and while holding the nut, push in the lock.
Do not rotate the nut excessively as it may damage the internal spring and transmission control cable assembly will not be reusable.
| *1 | Clip A |
| *2 | Clip B |
| *3 | Lock |
| *a | Protrusion |
Install the transmission control cable assembly to the floor shift shift lever assembly.
Install the transmission control cable assembly with the protrusion of the cable outer facing upwards.
After installation, make sure that the lock is projecting from A as shown in the illustration.
Engage the clip B to connect the shift cable end of the transmission control cable assembly to the floor shift shift lever assembly.
Connect the select cable end of the transmission control cable assembly to the floor shift shift lever assembly with the clip A.
Install the transmission control cable assembly with the protrusion of the select cable end facing upwards.
Perform the installation with the clip A at the correct direction as shown in the illustration.
58151
2.INSTALL FRONT NO. 1 FLOOR HEAT INSULATOR
Install the front No. 1 floor heat insulator to the body with the 2 bolts and nut.
17410
3.INSTALL FRONT EXHAUST PIPE ASSEMBLY
57533B
4.INSTALL FRONT FLOOR CENTER BRACE
58810J
5.INSTALL CONSOLE BOX ASSEMBLY
58839A
6.INSTALL CONSOLE BOX HOLE COVER
58916
7.INSTALL BOX BOTTOM MAT
58912C
8.INSTALL NO. 2 SIDE BOX PANEL
58911A
9.INSTALL NO. 1 SIDE BOX PANEL
58817A
10.INSTALL NO. 2 FRONT CONSOLE BOX INSERT
58816D
11.INSTALL NO. 1 FRONT CONSOLE BOX INSERT
for LHD:
Click hereVehicle Interior>INTERIOR PANELS / TRIM>UPPER INSTRUMENT PANEL>INSTALLATION
for RHD:
Click hereVehicle Interior>INTERIOR PANELS / TRIM>LOWER INSTRUMENT PANEL>INSTALLATION
58910C
12.INSTALL REAR CONSOLE BOX ASSEMBLY
74410
13.INSTALL BATTERY CARRIER ASSEMBLY
74431
14.INSTALL BATTERY TRAY
15.INSTALL BATTERY
17701
16.INSTALL AIR CLEANER CASE SUB-ASSEMBLY
17801
17.INSTALL AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY
18.INSTALL AIR CLEANER CAP SUB-ASSEMBLY
17880
19.INSTALL AIR CLEANER HOSE ASSEMBLY
12262
20.CONNECT NO. 2 VENTILATION HOSE
21.INSPECT FOR EXHAUST GAS LEAK
Perform "Inspection After Repairs" after repairing gas leaks in the exhaust system.
Click hereEngine / Hybrid System>2NR-FE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION