If the air inlet mode cannot be changed between recirculation/fresh or exhaust gas odors can be smelled even though recirculation mode is selected, the following factors may be the cause.
| Symptom | Factor |
|---|---|
·
Air inlet mode cannot be changed between recirculation/fresh ·
Exhaust gas odors can be smelled when air inlet mode set to recirculation mode |
·
No. 1 blower damper servo sub-assembly malfunction ·
Damper link disconnection ·
Air inlet damper mechanically locked ·
Engine coolant temperature (high) ·
Air conditioner unit assembly malfunction |
Check that the No. 1 blower damper servo sub-assembly is installed correctly.
Click hereVehicle Interior>HEATING / AIR CONDITIONING>BLOWER UNIT>REASSEMBLY
The No. 1 blower damper servo sub-assembly is installed correctly.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Check for DTCs.
| Result | Proceed to |
|---|---|
| B143A87 and B143B7F is not output | A |
| B143A87 is output | B |
| B143B7F is output | C |
A
B
C
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Coolant Temperature | Engine coolant temperature | Min.: -40°C (-40°F), Max.: 140°C (284°F) | 75 to 100°C (167 to 212°F): After warming up | This is the engine coolant temperature.
|
| Tester Display |
|---|
| Coolant Temperature |
The value of the display does not change frequently.
| Result | Proceed to |
|---|---|
| OK (for LHD) | A |
| OK (for RHD) | B |
| NG (for 1KR-FE) | C |
| NG (for M15A-FKS) | D |
A
B
C
D