33820B
1.INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY
Pass the transmission control cable assembly into the vehicle and install the transmission control cable assembly to the vehicle body with the 2 nuts.
Engage the guide and connect the transmission control cable assembly to the vehicle body.
Install the nut.
| *a | Paint Mark |
Install the transmission control cable assembly to the control cable bracket assembly with 2 new clips (B).
Make sure that the paint marks on the transmission control cable assembly are aligned with the slits in the control cable bracket assembly before installing the clips.
Connect the transmission control cable assembly to the manual transaxle assembly with the 2 clips (A).
| *a | Twist the stopper |
| *b | Pull |
| *c | Return the stopper |
| *d | Lock Piece |
| *e | Stopper |
| *f | Adjuster Case |
Release the lock of the transmission control select cable length adjustment structure.
Twist the stopper.
Pull the lock piece outward from the adjuster case to release the lock.
Return the stopper.
Engage the 2 claws to connect the transmission control cable assembly to the floor shift shift lever assembly.
Do not forcibly pull the transmission control cable assembly into the cabin.
Connect the transmission control shift cable to the floor shift shift lever assembly.
Connect the transmission control select cable to the floor shift shift lever assembly and install the clip.
Make sure that the lock piece of the transmission control select cable length adjustment structure is facing upward when the transmission control select cable is connected.
Make sure that the transmission control select cable is securely installed.
33820B
2.ADJUST TRANSMISSION CONTROL CABLE ASSEMBLY
58910C
3.INSTALL REAR CONSOLE BOX ASSEMBLY
58153
4.INSTALL FRONT NO. 2 FLOOR HEAT INSULATOR
Install the front No. 2 floor heat insulator to the vehicle body with the 3 nuts.
58166A
5.INSTALL FRONT FLOOR COVER LH (w/ Cover)
58165C
6.INSTALL FRONT FLOOR COVER RH (w/ Cover)
Use the same procedure as for the LH side.
17410
7.INSTALL FRONT EXHAUST PIPE ASSEMBLY
57543C
8.INSTALL CENTER NO. 1 FLOOR BRACE (w/ Brace)
74404A
9.INSTALL BATTERY CLAMP SUB-ASSEMBLY
89661
10.INSTALL ECM
17701
11.INSTALL AIR CLEANER CASE SUB-ASSEMBLY
17801
12.INSTALL AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY
13.INSTALL AIR CLEANER CAP WITH AIR CLEANER HOSE
14.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
15.INSPECT FOR EXHAUST GAS LEAK
16. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE
When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART