Home › Engine / Hybrid System › M15A-FXE (ENGINE MECHANICAL) › ENGINE UNIT › from 2020.07
RM36W0E _51 Engine / Hybrid System _089412 M15A-FXE ENGINE MECHANICAL _0424639 ENGINE UNIT A

M15A-FXE ENGINE MECHANICAL  ENGINE UNIT  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:

This procedure includes the installation of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


PROCEDURE

Hide 1.INSTALL WIRE HARNESS CLAMP BRACKET

a.
A458224

Using an 8 mm socket wrench, install the wire harness clamp bracket to the camshaft housing sub-assembly with the 2 bolts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


b.
A466430

Install the wire harness clamp bracket to the camshaft housing sub-assembly with the bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


Hide 12262 2.INSTALL NO. 2 VENTILATION HOSE

a.

Connect the No. 2 ventilation hose to the cylinder head cover sub-assembly and slide the clip to secure it.


Hide 16281 3.INSTALL NO. 4 WATER BY-PASS HOSE

a.
A458222

Install the No. 4 water by-pass hose to the water outlet and slide the clip to secure it.


b.

Engage the clamp.


Hide 4.INSTALL NO. 1 WATER BY-PASS PIPE ASSEMBLY

a.
A458217

Install the No. 1 water by-pass hose assembly to the water inlet with thermostat sub-assembly and slide the clip to secure them.


b.

Install the bolt.

Torque:
21 N*m (214 kgf*cm, 15 ft.*lbf)


Hide 11452D 5.INSTALL OIL LEVEL GAGE GUIDE

a.

Apply a light coat of engine oil to a new O-ring.


b.

Install the O-ring to the engine oil level dipstick guide.


c.

Using an 8 mm socket wrench, install the engine oil level dipstick guide to the cylinder head sub-assembly with the bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


d.

Install the engine oil level dipstick.


Hide 82219C 7.INSTALL SENSOR WIRE

a.
A466429

Engage the clamp.


b.

Install the sensor wire to the water inlet with thermostat sub-assembly with the bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


Hide 23250 8.INSTALL FUEL INJECTOR ASSEMBLY

Hide 22030 10.INSTALL THROTTLE BODY WITH MOTOR ASSEMBLY

Hide 17167 13.INSTALL NO. 1 EXHAUST MANIFOLD HEAT INSULATOR

Hide 25733A 14.INSTALL NO. 1 VACUUM PIPE (w/ Differential Pressure Sensor)

Hide 89481B 15.INSTALL DIFFERENTIAL PRESSURE SENSOR (w/ Differential Pressure Sensor)