Home › Vehicle Exterior › WINDOW / GLASS › WINDSHIELD GLASS (for 3 Door) › from 2020.09
RM36W0E _59 Vehicle Exterior _088018 WINDOW / GLASS _0447338 WINDSHIELD GLASS(for 3 Door) A

WINDOW / GLASS  WINDSHIELD GLASS(for 3 Door)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during the windshield glass removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part Necessary Procedure Effect/Inoperative Function when Necessary Procedures are not Performed Link
Windshield glass Adjust forward recognition camera
·

Dynamic Radar Cruise Control System

·

Front Camera System

·

Lane Tracing Assist System

·

Road Sign Assist System

·

Pre-collision System

·

Auto High Beam System


One Time Recognition:
(Click here)
Sequential Recognition:
(Click here)
Driving Adjustment:
(Click here)

NOTICE:

When replacing the windshield glass of a vehicle equipped with a forward recognition camera, make sure to use a Toyota genuine part. If a non-Toyota genuine part is used, the forward recognition camera may not be able to be installed due to a missing bracket. Also, the dynamic radar cruise control system, lane tracing assist system, road sign assist system, pre-collision system, front camera system or auto high beam system may not operate properly due to a difference in the transmissivity or black ceramic border.


PROCEDURE

Hide 1.REMOVE WINDSHIELD WIPER MOTOR AND LINK

Hide 8646C 2.REMOVE FORWARD RECOGNITION CAMERA (w/ Pre-collision System)

Hide 86401 3.REMOVE FORWARD RECOGNITION WITH HEATER HOOD SUB-ASSEMBLY (w/ Pre-collision System)

Hide 89941 4.REMOVE RAIN SENSOR (w/ Rain Sensor)

Hide 87810 5.REMOVE INNER REAR VIEW MIRROR ASSEMBLY

Hide 62312B 6.SEPARATE FRONT DOOR OPENING TRIM WEATHERSTRIP LH

a.
B590297

Separate the front door opening trim weatherstrip LH.


Hide 62311B 7.SEPARATE FRONT DOOR OPENING TRIM WEATHERSTRIP RH

HINT:

Use the same procedure as for the LH side.


Hide 62212 8.REMOVE FRONT PILLAR GARNISH LH

Hide 62211 9.REMOVE FRONT PILLAR GARNISH RH

HINT:

Use the same procedure as for the LH side.


Hide 81260A 10.REMOVE MAP LIGHT ASSEMBLY

Hide 74320 11.REMOVE VISOR ASSEMBLY LH

Hide 74310 12.REMOVE VISOR ASSEMBLY RH

HINT:

Use the same procedure as for the LH side.


Hide 74348B 14.REMOVE VISOR HOLDER RH

HINT:

Use the same procedure as for the LH side.


Hide 74610A 16.REMOVE ASSIST GRIP SUB-ASSEMBLY

Hide 63311C 17.SEPARATE ROOF HEADLINING

a.
B590298

Slightly lower the front section of the roof headlining so that the windshield glass can be removed.

NOTICE:

Do not damage the roof headlining or vehicle interior.


HINT:

It is not necessary to completely remove the roof headlining.



Hide 56111 18.REMOVE WINDSHIELD GLASS

a.
B590299C01
0,0 0,0 false
V100155

Protective Tape


Apply protective tape to the area around the installation position of the windshield glass on the vehicle body to prevent it from being scratched.


b.
B590300C01
1.167,1.813 1.646,1.677 1.646,1.677 1.302,1.615 true 1.708,1.563 1.917,1.75 0.208,0.188 10 true *a
*a Matchmark


Place matchmarks on the windshield glass and vehicle body at the locations indicated in the illustration.

HINT:

Matchmarks are not necessary if the windshield glass is not going to be reused.



c.
B590301C01
1.573,1.531 1.865,1.281 true 0.719,0.188 1,0.385 true 2.417,0.385 2.594,0.188 true 1.906,1.198 2.104,1.354 0.198,0.156 10 true *a 0.563,0.073 0.74,0.229 0.177,0.156 10 false *1 2.615,0.083 2.792,0.24 0.177,0.156 10 false *1
*1 Windshield Glass Stopper
*a Piano wire


Pass a piano wire between the vehicle body and windshield glass from the interior.


d.

Tie both wire ends to wooden blocks or similar objects that can serve as handles.


e.

Cut the adhesive by pulling the piano wire around the windshield glass.

NOTICE:
·

When separating the windshield glass, be careful not to damage the paint or interior and exterior ornaments.

·

To prevent the instrument panel safety pad sub-assembly from being scratched when removing the windshield glass, place a plastic sheet between the piano wire and instrument panel safety pad sub-assembly.




f.
B590302C01
0.917,1.042 1.125,0.75 false 0.75,1.052 1.063,1.25 0.313,0.198 10 false *1
*1 Windshield Glass Stopper


Disengage the windshield glass stoppers.

NOTICE:
·

The windshield glass stoppers are installed to the windshield glass as shown in the illustration. Be careful not to damage the windshield glass when cutting the adhesive.

·

To prevent the windshield glass rom falling when performing this operation, be sure to hold the windshield glass using suction cups.




g.

Using suction cups, remove the windshield glass.

NOTICE:
·

Be careful not to drop the windshield glass.

·

Leave as much adhesive on the vehicle body as possible when removing the windshield glass.




Hide 75533G 19.REMOVE WINDSHIELD OUTSIDE MOULDING

a.

When reusing the windshield glass:

i.
B590303C01
0.125,0.125 0.438,0.323 0.313,0.198 10 false *a
*a Back Side of Windshield Glass


Using a scraper, remove the windshield outside moulding.

NOTICE:
·

Be careful not to damage the windshield glass.

·

Be sure to replace the windshield outside moulding with a new one.





Hide 56118A 20.REMOVE NO. 2 WINDOW GLASS ADHESIVE DAM

a.

When reusing the windshield glass:

i.
B590304C01
0.115,0.094 0.427,0.25 0.313,0.156 10 false *a
*a Back Side of Windshield Glass


Using a scraper, remove the No. 2 window glass adhesive dam.

NOTICE:
·

Be careful not to damage the windshield glass.

·

Be sure to replace the No. 2 window glass adhesive dam with a new one.





Hide 56117A 21.REMOVE WINDOW GLASS ADHESIVE DAM

a.

When reusing the windshield glass:

i.
B590305C01
0.115,0.094 0.427,0.25 0.313,0.156 10 false *a
*a Back Side of Windshield Glass


Using a scraper, remove the window glass adhesive dam.

NOTICE:
·

Be careful not to damage the windshield glass.

·

Be sure to replace the window glass adhesive dams with a new one.





Hide 56115C 22.REMOVE WINDSHIELD GLASS STOPPER

a.

When reusing the windshield glass:

i.
B590306C01
0.208,0.188 0.521,0.385 0.313,0.198 10 false *a
*a Back Side of Windshield Glass


Using a scraper, remove the 2 windshield glass stoppers.

NOTICE:
·

Be careful not to damage the windshield glass.

·

Be sure to replace the windshield glass stoppers with a new one.