Home › Vehicle Exterior › DOOR / HATCH › HOOD LOCK CONTROL CABLE ASSEMBLY (for LHD) › from 2020.09
RM36W0E _59 Vehicle Exterior _088480 DOOR / HATCH _0443171 HOOD LOCK CONTROL CABLE ASSEMBLY(for LHD) A

DOOR / HATCH  HOOD LOCK CONTROL CABLE ASSEMBLY(for LHD)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front bumper assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function When Necessary Procedures are not Performed Link
Front bumper assembly (Including removal and installation)
·

Ultrasonic sensor detection angle

·

Ultrasonic sensor detection angle registration


Parking support brake system (Click here)

PROCEDURE

Hide 1.REMOVE FRONT BUMPER ASSEMBLY (for 5 Door)

Hide 2.REMOVE FRONT BUMPER ASSEMBLY (for 3 Door)

Hide 53876A 4.REMOVE FRONT FENDER LINER LH

HINT:

Use the same procedure as for front fender liner RH.

Click hereVehicle Exterior>WIPER / WASHER>WASHER MOTOR>REMOVAL


Hide 53510 5.REMOVE HOOD LOCK ASSEMBLY

a.

w/ Engine Hood Courtesy Switch:

i.
B594323C03
2.417,0.615 1.094,0.969 1.094,0.969 1.125,0.656 true 2.917,0.583 3.031,0.396 true 0.979,0.99 1.188,1.198 0.208,0.208 10 true *a 3.01,0.167 3.24,0.396 0.229,0.229 10 true *b
*a Clamp
*b guide


Disconnect the connector.


ii.

Disengage the clamps and guide.



b.

Remove the 3 bolts.


c.
B594324

Disengage the guide to disconnect the hood lock control cable assembly, and remove the hood lock assembly.


Hide 55606 6.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Hide 53601 7.DISCONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

Hide 53601 8.REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

a.
B576027

Disengage the guide.


b.

Disconnect the hood lock control cable assembly to remove the hood lock control lever sub-assembly.


Hide 53630 9.REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY

a.

Disconnect the hood lock control cable assembly from the clamps.

B594325C01
2.625,2.25 2.625,2.083 true 2.573,2.26 2.802,2.427 0.229,0.167 10 true *a
*a Grommet - -



b.

Disengage the grommet.


c.

Pull the hood lock control cable assembly from the engine compartment to remove it.