Home › Engine / Hybrid System › G16E-GTS (COOLING) › WATER PUMP › from 2020.09
RM36W0E _51 Engine / Hybrid System _095909 G16E-GTS COOLING _0449888 WATER PUMP A

G16E-GTS COOLING  WATER PUMP  INSTALLATION  


PROCEDURE

Hide 16031 1.INSTALL WATER INLET WITH THERMOSTAT SUB-ASSEMBLY

Hide 16032 2.INSTALL WATER INLET WITH WATER PUMP HOUSING SUB-ASSEMBLY

a.

Install a new gasket to the water inlet with water pump housing sub-assembly.

HINT:

Be sure to clean the contact surfaces.



b.

Install the water inlet with water pump housing sub-assembly to the cylinder block sub-assembly with the bolt and 2 nuts.

Torque:
43 N*m (438 kgf*cm, 32 ft.*lbf)


c.

Connect the No. 4 water by-pass hose to the water inlet with thermostat sub-assembly and slide the clip to secure it.


Hide 17871 3.INSTALL AIR CONNECTOR STAY

a.

Install the air connector stay to the water inlet with water pump housing sub-assembly with the bolt.

Torque:
43 N*m (438 kgf*cm, 32 ft.*lbf)


Hide 16572D 4.INSTALL NO. 2 RADIATOR HOSE

a.

Connect the No. 2 radiator hose to the water inlet with thermostat sub-assembly and slide the clip to secure it.


Hide 16282 5.INSTALL NO. 5 WATER BY-PASS HOSE

a.

Connect the No. 5 water by-pass hose to the water inlet with water pump housing sub-assembly and slide the clip to secure it.


Hide 16173 7.INSTALL WATER PUMP PULLEY

a.

Temporarily install the water pump pulley to the water pump with the 4 bolts. Tighten the bolts as much as possible by hand.


b.

Install the fan and generator V-belt.

Click hereGeneral>MAINTENANCE>G16E-GTS DRIVE BELT>INSTALLATION


c.

Tighten the 4 bolts of the water pump pulley.

Torque:
21 N*m (214 kgf*cm, 15 ft.*lbf)


Hide 9.ADD ENGINE COOLANT

Hide 51410 11.INSTALL NO. 1 ENGINE UNDER COVER ASSEMBLY